Samson manual Changing the MPL 1640 from Rack-mount to Tabletop

Page 25

Changing the MPL 1640 from Rack-mount to Tabletop

The diagrams below show the steps required to convert the MPL 1640 from rack-mount to tabletop usage or vice-versa. CAUTION: These servicing instructions are for use by qualified personnel only. Refer all servicing to qualified service personnel.

TABLETOP ARRANGEMENT

JACKFIELD 6 SCREWS

	REMOVE	COVERPLATE
	SCREWS
		3 SCREWS

REMOVE

ARMREST

(4 SCREWS)

RACKMOUNT EAR

COVERPLATE 3 SCREWS

JACKFIELD 6 SCREWS

RACKMOUNT ARRANGEMENT (REAR FACING JACKFIELD)

REMOVE COVERPLATE SCREWS

23

Image 25

Contents Page Setting Up and Using the MPL 1640 Connecting the MPL 1640Introduction Guided TourIntroduction MPL 1640 FeaturesIntroduction Samson Guided Tour OverviewGuided Tour Channel Guided Tour Channel MPL Guided Tour Main SectionGuided Tour Main Section MPL Guided Tour Rear PanelGuided Tour Rear Panel Sleeve TIP Ring TIP + Ground Ring Connecting The MPLSleeve TIP Ring TIP Return Ground Ring Send Setting the Correct Gain Structure Setting Up and Using the MPLSetting Up and Using the MPL PM EST Grounding Techniques Grounding Techniques Using Bus 3/4 Using Pan Using Equalization Using the Auxiliary Sends and Returns Using Channel Inserts Using PFL Solo Changing the MPL 1640 from Rack-mount to Tabletop Applications Application 1 Using the MPL 1640 as a main live mixerApplication 2 Using the MPL 1640 as an onstage monitor mixer Application 3 Using the MPL 1640 as a keyboard submixer Compressor / Limiter DAT Application 4 Using the MPL 1640 as a recording mixerAppendix a Changing the MPL 1640 Voltage Return Appendix B Block DiagramFrequency Response SpecificationsMaximum Input Level ±3 dB