3.Drain water from Pasta System.
4.Fill Pasta System vessel with water. See page 7 – Filling.
UNDER NO CIRCUMSTANCES SHOULD THE PASTA SYSTEM BE LEFT UNATTENDED DURING
5.Turn Pasta System on and bring water and a gentle boil.
6.Once boil has been reached, turn Pasta System off.
7.Dissolve 3 cups of vinegar for every five gallons of warm water and let soak for one hour. If there is a large
8.While soaking, a natural fiber brush may be used to scrub the tubes and inside walls of Pasta System vessel.
9.Drain the water and vinegar.
10.Spread Keating Klenzer liberally on elements and sides of Pasta System vessel.
11.At this point, a
12.Thoroughly rinse Pasta System vessel with potable water to remove all Klenzer.
13.Prior to refilling with water, wipe the inside of the Pasta System vessel making sure all water and Klenzer has been removed.
14.Close drain valve.
15.Refill the Pasta System with fresh water. See page 7 – Filling.
HOW TO PROGRAM THE “KEATING” ELECTRONIC TIMER – PART #023709
STEP 1 Make certain power to the timer has been OFF for at least 30 seconds. Then PRESS and hold down the UP arrow button while turning the rocker power switch to the ON position.
NOTE: If power switch does not turn off timers, the unit must be unplugged (two people may be needed).
The timer will turn ON and the display will now be
indicating
|
|
|
|
|
– – – |
| – | •– – |
|
| OR |
| • |
|
|
|
|
The BEEPER will BEEP 4 times.
NOTE: If STEP 1 was OK, proceed to STEP 2. If not, retry Step 1 making sure the power was OFF for at least 30 seconds or more.
STEP 2 PRESS all 3 buttons in sequence:
1:00
TIMER OPERATING INSTRUCTIONS
DIGITAL TIMERS
PART #056921 – REPLACES PART #023709
The electronic timers provide a clearly visible and accurate display and are very easy to use.
A. PROGRAMMING
To program the timers, the unit must be in the idle mode. Press and hold the set button for approximately two seconds. The display
will show “SEt”. Press the button for the 1:00 channel to be programmed. The display
will show the current setting for that channel. Use the up or down button to
increment or decrement the setting. When the setting is correct, press and hold the set button again for approximately two seconds. The display will show "StO" for approximately two seconds and the timer will return to normal operation. Repeat the process as necessary for the other timers.
B. OPERATING LOGIC
When the timer is powered up, the display will show the time setting for the channel that was operated last and the relay output contacts will be open. To start a cycle, press the desired channel button
7