General Cleaning Ccont nuedl
Turn the warmer
drawer control knob to OFF before removing the drawer. DO NOT touch the warmer drawer element. The element may still be hot enough to cause burns, even if it is dark in color.
To Remove and Replace Warmer Drawer
To Remove Warmer Drawer:
.Turn power off before removing the warmer drawer.
2.Open the drawer to the fully opened position.
3.Locate the latches on both sides of the warmer drawer.
4.Pull up on the left glide latch and push down on the right glide latch.
. Pull the drawer away from the appliance.
6.To clean warmer drawer, gently scour with a soapy scouring pad; this will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difflcult spots with an ammonia- soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth. Remove all cleaners or the porcelain may become damaged during future heating. DO NOT use spray oven cleaners on the cooktop.
To Replace Warmer Drawer:
1.Align the glide latches on both sides of the drawer with the slots on the drawer.
2.Push the drawer back into the appliance.
Electrical Shock Hazard can occur and
result in serious injury or death. Disconnect appliance
from electric power before cleaning and servicing the warmer drawer.
Warmer Drawer
Avoid Service Checklist Before you calt for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result
of defective workmanship or materials in this appliance.
OCCURRENCE
Drawer is not level.
Cannot move appffance
easffy. Appffance must be accesslble for service.
Warmer drawer does not
operate.
POSSIBLE CAUSE/SOLUTION
Poor installation. Place a level on the cutout bottom. Make sure bottom is level.
Be sure cutout bottom is strong and stable enough to adequately support drawer (and wall oven, if applicable).
Cabinets not square or are built in too tightly. Contact builder or installer to make appliance accessible.
Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company for service.
An error at power up (or after a power failure) could happen if the control knob was left on the ON position. If a power failure should occur, be sure to set the control knob to the OFF position. This will reset the electronic controls. Once the control knob has been set to the OFF position, the electronic controls should return to normal operation.