Kenmore 17568563 manual Ir!l, If you

Page 6

I'r!l

11WE'REREADY TO MAKE THE ELECTRICAL CONNECTIONS.

NOTE: Ifusing armored cable, we recommend installing an anti-short or insulation bushing in the end of the cable,

A_onnector

Wire nut

Do not fold or remove the ! brown electrical insulation paper from inside the wiring compartment,

Install the cable connector. Then

loosen the connector screw(s). (Some disposers have a connec- tor built in, on ethers you will have to instalt one which must meet local electrical codes).

Work the cable from the on-off

switch through the connector so that the leads are in the electrical

widng area in the disposer base.

Connect the two power wires to the cable wires, making sure

you connect white to white and black to black, Secure the

wires with wire nuts by twisting them to the right (clockwise).

Now, tighten the connector clamp screw{s) to hold the cable in place.

Finally, place the connected " wires back in the compartment.

 

If you are using the built-in

 

Screws

cable

clamp

loosen the two

 

 

screws until cable will freely

W=re nut

 

enter

under

the clamp.

 

 

F.

Plug

If you

are using "Greenfield"

 

Cable

then the plug must be

removed.

Wire nul

Finally, place the connected wires back in the compartment.

Replace electrical plate.

Work the cable from the on-offswitch through the connector so thatthe leads are in the elec-

trical wiring area in the disposer base.

Now, tighten the connector clamp screw{s) to hold the cable in place.

Connect the two power wires to the cable wires, making sure you connect white to white and black to black. Secure the wires with wire nuts by twisting them to the right (clockwise).

Install the cable connector. Then

loosen the connector screwls I. Work the cable from the on-off switch through the connector so thatthe leads are in the elec-

trical wiring area in the disposer base.

Now, tighten the connector clamp screw(s) to hold the cable in place.

Connect the two power wires to the cable wires, making sure you connect white to white and black to black, Secure the

wires with wire nuts by twisting them to the right (clockwise).

Image 6
Contents Food Waste Disposers HOW this Guide will Help YOUOKAY, Lets Start Installation ONE Step AT a Time Cleaning Your Sinks Drain Line Removing Your OLD DisposerNow, push the strainer up through Sealant from RIM Clean the OLD Sink HoleSUPPLY.@ Electrical Disposer sink sleeveLets Keep GOING...ITS Getting EASIER, WE Hope Ir!l If youConnection Tube TOO SHORT? If Dishwasher Drain ConnectionDischarge PlPler ClampDisposer PLACENOW, .LOCKTHE Check Disposer OperationCare and USE Operating Instructions LeaksUser Maintenance Instructions Important Safety Instructions