w
LET'S KEEP GOING...IT'S GETTING EASIER, WE HOPE.
7 NOW WE'RE GETTING INTO THE ACTUAL INSTALLATION. SEPARATE THE PARTS IN THE MOUNTING ASSEMBLY.
Mounting | _,_ | Lower |
Assembly | / | _Mounting " |
|
| Ring |
First, remove | the mounting assembly | Then loosen the screws | on the moun- | ||
from the dower mounting | ring, Holding | ting assembly | until they | are just level | |
the mounting | assembly | with one hand, | with the surface | of the mounting ring. | |
insert your wrenchette | or screwdriver |
|
|
|
inlo one of the lugs of the tower moun- ting ring end turn it to the Jeff
(counterclockwise) with your other hand
8 APPLY PUTTY TO THE
SINK SLEEVE.
A=,, |
|
|
| B. |
Make | a | fat snake | of "plumber's" | Apply this roll under the rim of the |
patty | by | rolling | it between your | sink steeve |
hands. |
|
|
|
|
ID
Groove '_
SineSleeve
• _.%°"°g
Now, | use a screwdriver to pry off the | The assembly will now | come apart. Set |
snap | ring | it aside and move to the | next step. |
UPPER MOUNTING
NEXT, LET'S ATTACH THE
ASSEMBLY.
|
|
|
|
|
|
| B, |
|
First, | working | from | under | the sink, | slip the | Hold the fiber gasket and metal back- UP | ||
fiber | gasket | and | next | the | metal | ring in place | with one hand and place | |
ring | (flat side | up} | up | and | over the sink | the mounting | ring with its three screws onto | |
sleeve, |
|
|
|
|
| the sink sleeve. |
Then, place the sink sleeve into the sink drain hole and push down gently but firmly to make sure it sits evenly in the putty.
DISPOSER UPSIDE
0TURNDOWN YOURAND REMOVENEW THE ELECTRICAL
PLATE FROM THE DISPOSER SO YOU CAN SEE THE WIRING AND THE GROUND SCREW. THE BOTTOM OF YOUR DISPOSER WILL LOOK LIKE THE ONES SHOWN IN 'A'OR 'B'.
(Start here if you are replacing a disposer with the same mouni_ng.)
Remove the electrical plate lrom the bottom of the disposer and pull out the black and white electrical wires The green ground screw is also under this plate.
BLrrTON
rC_
Now, push the fiber gasket, metal
ring and the mounting ring further up on the sink sleeve. Slide the snapring onto the sink
sleeve until it POps into place in the groove :_nthe sleeve.
T_hten the three mounting screws with
your screwdriver until the whole mounting assembly te seated evenly and t_ghtly
againstthe sink.