General Care & Cleani
Changing the Oven Light
Oven
Light.
Wire
Holder
i !i iiiiiiiiiiii !
ng
The oven light automatically turns ON when the door isopened. The oven light may also be manually operated by pressing the Oven Light switch located on the upper left control panel.
The oven light bulb is located at the rear of the oven and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light bulb:
1.Turn electrical power off at the main source or unplug the range.
2.Press wire holder to one side to release the glass shield.
3.Replace bulb with a new 40 watt appliance bulb.
4.Replace glass shield over bulb and snap wire holder into place.
5.Turn power back on again at the main source (or plug the range back in).
6.The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Guide.
Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a
Care and Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the Care & Cleaning table for detailed cleaning instructions.
Adjusting the Oven Temperature
Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
1.Press Bake
2.Set the temperature to 550°F (287°C) by pressing and holding the A.
3. Within 2 seconds, press and hold _ untilthe2digitdisplayappears. | Release_.Thedisplaynowindicatestheamount |
of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."
4. Thetemperaturecann_wbeadjustedup_rd_wn35°F(17°c)_in5°Fstepsbypressingandh_ldingtheA or V.Adjust
until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign
5.When you have made the desired adjustment, press _ to go back to the time of day display.
Note: Oven temperature adjustments made will not change the
23