Nilfisk-ALTO 5 SB FA Before starting the cleaner, Transport and assembly, Set the brake

NEPTUNE 5 SB FA

2.2Operating elements See fold-out page at front of these 17. Detergent metering knob

operating instructions.		18.	Pressure gauge
		19.	Power ON
1.	Spray lance	20.	Castor with parking brake
2.	Cylinder lock	21.	Water supply connection
3.	Cover for control panel	22.	Tank fi ller for anti-freeze
4.	Fuel level gauge	23.	Tank fi ller for Nilfi sk-Alto
5.	Tank fi ller for fuel		Anti-Scale
6.	Receptacle for service crane	24.	Canister for detergent B1)
	and lifting ring1)	25.	Tank fi ller for detergent A
7.	Top cover release	26.	Grip for top cover
8.	Service door release	27.	Cylinder lock
9.	High pressure hose	28.	Selector switch shampoo/
	connection		rinsing
10.	Main switch ON/OFF - cold	29.	Low detergent indicator
	water/hot water	30.	Coin tester

11.Display (Temperature or Codes)

12.Temperature control

13.Low fuel indicator

14.Low Nilfi sk-Alto AntiStone (Anti-Scale) indicator

15.Service interval due/expired

16.Pump oil low

3 Before starting the cleaner

3.1Transport and assembly

1.The safest way to lift the ma- chine is to use a fork-lift truck The arrows in the illustration indicate the best places to po- sition the fork.

2.It is also possible to lift the ma-

3.2Set the brake

chine by hand from the pallet. Due to the weight this work should be done by at least three persons.

CAUTION!

Do not hold the plastic tank to lift the machine as it could become detached from the frame.

The best places to hold the ma- chine are

–on the handle

–on the frame between the front wheels and the guide rollers.

Every fuel-burning appliance, such as pressure washers, depends upon a proper mix of fuel and air (by weight) for proper combustion. Therefore some adjustment of the

air supply to the burner may be nec- essary to take account of altitude and the resulting air pressure. This is true whether your fuel is ‘Natural gas’, Propane or Diesel.

Your Nilfisk-ALTO hot water pres- sure washer was thoroughly tested and adjusted for optimum perform- ance before it left our factory. The factory is located at approximately 120m (390 ft) above sea level, and the combustion settings are optimal for that elevation.

If your location is higher than 1200m (3900 ft) above sea level, your burner may require re-ad- justment for proper performance and best fuel economy. Contact your Dealer or Nilfisk-ALTO for assistance.

1.Before using the cleaner for the first time, check it careful- ly for any faults or damage.

2.Run the machine only when it is in perfect working condi- tion.

3.Set the brake.

4.The slope on which the high pressure cleaner is placed must not exceed more than 100 in any direction.

1) Options / model variants 5