3.7Fill up fuel tank
The fuel must be free from con- tamination.
Tank capacity see chapter 9.4 Technical data.
NOTE!
At temperatures below 8°C (46°F), the fuel oil begins to so- lidify (paraffi n precipitation). This can lead to diffi culties in starting the burner. Before the winter
NEPTUNE 5 SB FA
With the machine cold, turned off and disconnected from power supply:
1.Fill fuel tank from a clean con- tainer with a fresh fuel (fuel oil EL, or Diesel oil DIN 51 603), or fuel type recommended by your distributor.
months it is recommended that a fuel conditioner/stabilizer be added (available from the fuel oil trade).
3.8 Connecting the high
pressure hose 3.8.1 Machines with high
pressure hose reel1)
3.8.2 Machines without high pressure hose reel
B |
C |
A |
1.Connect the high pressure hose quick connector to the high pressure nipple (A) lo- cated at the hose reel axle.
2.Place the high pressure hose into the hose guide (B) and ritain it with the clip.
3.Release the brake (C) on the hose reel and wind up the high pressure hose.
1.Connect the high pressure hose quick connector to the high pressure nipple located at right rear of machine above chemical tank.
3.9Connecting the water supply
NOTE!
See chapter 9.4 Technical Data for required quantity of water and water pressure.
In the case of poor water quality (sand, etc.), it is recommended that an inlet water fi lter be in- stalled.
1.Attach quick connect adapter found with Owners Manual to the water supply hose.
2.Rinse the water supply hose briefly in order to prevent sand an other dirt particles entering into the machine.
3.Attach water supply hose with adapter to inlet quick connec- tor.
4.Open water supply faucet.
Water supply hose should be a reinforced hose and have a minimum inside diameter of 3/4" (19 mm).
1) Options / model variants | 7 |
