Kenmore 790. 7859 manual General Care & Cleaning cont’d, To Remove Oven Door, To Replace Oven Door

Page 14

General Care & Cleaning (cont’d)

Cleaning the Contoured Well Areas, Burner Cap, Burner Head and Burner Drip Pans (some models)

The contoured well areas, burner cap, burner head and burner drip pans (some models) should be routinely cleaned. Keeping the burner ports clean will prevent improper ignition and an uneven flame. Refer to the following instructions:

Fig. 2

Fig. 3

Door Hinge locations with oven door fully open

Fig. 1

To Clean the Recessed & Contoured Areas of the Cooktop - If a spill occurs on or in the recessed or contoured areas, blot up spill with an absorbent cloth. Rinse with a clean, damp cloth and wipe dry.

To Remove and Replace the Surface Burner Caps & Surface Burner Heads - Remove in the following order: (1st) surface burner grate, (2nd) surface burner cap, (3rd) surface burner head and (4th) surface burner drip pan (if equipped).

Reverse the procedure above to replace the surface burner cap, surface burner head and surface burner drip pans (if equipped). Do not remove any parts from the cooktop until they have completely cooled and are safe to handle. Do not operate the surface burners without the surface burner cap and surface burner head properly in place.

To Clean the Surface Burner Cap, Surface Burner Head & Surface Burner Drip Pan (some models) - Use a soap-filled scouring pad or a mild abrasive cleanser to clean the surface burner caps, surface burner heads and surface burner drip pans (if equipped). The ports (or slots) around the burner head must be routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle to clean the slots or holes. For proper flow of gas and ignition of the burner—DO NOT ALLOW SPILLS,

FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS keep the surface burner cap and surface burner head in place whenever a surface burner is in use.

Removing & Replacing the Lift-Off Oven Door

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open oven door completely (horizontal with floor - See Fig. 1).

2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Fig. 2). A tool such as a small flat-blade screwdriver may be required.

3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3).

4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).

5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Fig. 4).

To Replace Oven Door:

1. Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3).

2. Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins.

3.Fully open the oven door (horizontal with floor - See Fig. 1).

4.Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Fig. 2) to the locked position.

5.Close the oven door.

Fig. 4

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Estufa a gas Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.ATable of Contents Important Safety Instructions For Your SafetyImportant Instructions for Usingyour Cooktop Important Safety NoticeConversion to Liquefied Petroleum Gas or L.P. Gas Range FeaturesYour Gas Range Features Include Master Protection Agreements U.S.AEn los EE.UU MY-HOMEBefore Setting Oven Controls Setting Proper Surface Burner Flame Size Setting Surface ControlsSetting Surface Controls Operating the Gas Surface BurnersTo Set the Minute Timer Setting Oven ControlsTemperature conversion Oven Control FunctionsTo Set Control for Continuous Bake or 12 Hour Energy Saving Setting Oven Controls cont’dTo Set or Change the Temperature for Baking To Set Control for Oven Lockout To Set for Broiling Self-Cleaning Self-Cleaning Oven To Operate the Oven Light some modelsTo Set the Controls for a Self-Clean Cycle Self-Cleaning cont’dStarting the Select Self-Clean Cycle Stopping or Interrupting a Select Self- Cleaning CycleGeneral Care & Cleaning Cleaning the CooktopTo Replace Oven Door General Care & Cleaning cont’dTo Remove Oven Door Changing the Oven Light some models Adjusting the Oven TemperatureTo Adjust Oven Temperature To replace the oven light bulbBefore You Call English
Top Page Image Contents