Kenmore 790. 7852, 790. 7862 Adjusting the Oven Temperature, Changing the Oven Light some models

General Care & Cleaning (cont’d)

Special Door Care Instructions - Most oven doors contain glass that can break. Read the following recommendations:

1.Do not close the oven door until all the oven racks are fully in place.

2.Do not hit the glass with pots, pans, or any other object.

3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

Changing the Oven Light (some models)

For models equipped with the interior oven light, the light bulb is located at the rear of the oven and is covered with a glass shield held by a wire holder (See Fig. 1). The glass shield must be in place whenever the oven is in use.

	To replace the oven light bulb:
	1.	Turn electrical power off at the main source or unplug the range.
	2.	Press wire holder to one side to release the glass shield.
	3.	Replace bulb with a new 40 watt appliance bulb.
	4.	Replace glass shield over bulb and snap wire holder into place.
	5.	Turn power back on again at the main source (or plug the range back in).
	6.	The clock will then need to be reset. To reset, see Setting the Clock and
		Minute Timer in this Use & Care Guide.
			Be sure the range is unplugged and all parts are COOL before replacing
Fig. 1	oven light. Wear a leather-faced glove for protection against possible broken glass.

Adjusting the Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1.Press .

2.Set the temperature to 550°F (287°C) by pressing and holding the .

3.Within 2 seconds, press and hold until the 2 digit display appears. Release . The display now indicates the amount

of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."

4.The temperature can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the or . Adjust

until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5.When you have made the desired adjustment, press to go back to the time of day display.

Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

ENGLISH

15