Kenmore 790. 7260 manual Before You Call Solutions to common problems

Page 25

Before You Call • Solutions to common problems

Problem

Surface burners do not ignite.

Surface burner flame only part way around burner cap.

Solution

•Surface control knob was not completely turned to LITE. Push in & turn the surface control knob to LITE until burner ignites and then turn control knob to desired flame size.

Burner ports are clogged. With the burner OFF, use a small-gauge wire or needle to burner head slots and ignition ports. See Cleaning the cooktop and surface burners in the Care & Cleaning section for additional cleaning instructions.

•Range power cord is disconnected from outlet (electric ignition models only). Be sure power cord is securely plugged into the power outlet.

•Electrical power outage. Burners may be lit manually. See section on Setting Surface Controls.

•Burner slots or ports are clogged. With the surface burner OFF, clean ports with a small-gauge wire or needle.

•Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is full.

Surface burner flame is orange.

•Dust particles in main gas line. Allow the burner to operate a few minutes until flame turns blue. In coastal areas, a slightly orange flame is unavoidable due to salt content in air.

25

Image 25

Contents Ienmoreo Contents Kenmore Limited WarrantyDefinitions Save these instructions for future referenceImportant Instructions for Using Your Oven Important Safety InstructionsCOOlTOP Important safety noticeGrounding Instructions Product Record Serial Plate LocationConversion to L.R Gas Removing, replacing and arranging racks Before Setting Oven ControlsTypes of oven racks Air circulation in the ovenUsing proper cookware Before Setting Surface ControlsSetting proper burner flame size Cookware material typesSetting surface burners Setting Surface ControlsHome canning Setting Clock Setting Oven ControlsSetting silent or audible control mode Oven Control FunctionsChanging temperature display F or C Setting Oven ControlsSetting Timer Oven Door To activate Oven Lockout feature Setting BakeTo cancel bake at anytime Oven LockoutWhen the cook time runs out Setting Cook TimePress Cook Time key pad will appear in display Setting Delay StartBroil Suggested broil settings table gas ovenSee 1st side ThickTo adjust oven temperature Adjusting oven temperatureRead before starting Select Clean Select CleanSetting Select Clean When Select Clean is finished Delayed Start Select CleanTo set Delay Start Select Clean If it becomes necessary to stop Select Clean when activeCleaning recommendation Care & CleaningCleaning burner caps Cleaning the cooktop and surface burnersCleaning surface burner heads To clean the burner head ignition portsAluminum foil and utensils Glass shield Wire HolderReplacing oven light some models To replace the interior oven light bulbSpecial door care instructions Removing and replacing the lift-off oven doorSee Adjusting SolutionInstalled ApplianceSection Before You Call Solutions to common problems Page Protection Agreements Sea/rs