READ AND SAVE THESE INSTRUCTIONS
TABLE OF CONTENTS |
|
SECTION | PAGE(S) |
Warranty | 2 |
Safety Instructions | 2 |
Operation | 3 |
Cleaning | 3 |
Parts Included With Hood | 4 |
Parts Not Included With Hood | 4 |
Tools Needed | 4 |
Range Hood System | 5 |
Equivalent Duct Length Chart | 6 |
Select Installation Type | 7 |
Wiring Installation | 8 |
Prepare the Hood | |
Install the Hood | |
Finalize the Installation | |
Installing Grease Filters | 13 |
Changing Light Bulbs | 13 |
Service Parts | 14 |
WARRANTY
Full One Year Warranty Including Parts and Labour
For one year from the date of purchase, when the range hood is installed and operated in Canada, in accordance with the instruction in the Owners Manual and Installation Instructions, Sears Canada Inc. (‘‘Sears’’) will repair, or replace at its option, mechanical or electrical parts, if defective in material and workmanship, and perform any necessary adjustments at no charge.
NORMAL RESPONSIBILITY OF THE CONSUMERS
The following are not covered by this warranty:
1.Parts and service resulting from damage caused by accident, negligence or commercial usage.
2.Parts and service required as a result of defective or inadequate fusing or house wiring.
3.Parts and service required as a result of fire, flood or Acts of God.
SEARS CANADA INC. TORONTO, ONTARIO M5B 2B8
Sears Maintenance Agreement... your way to buy tomorrow’s services at today’s prices...
and Sears Service is nationwide.
Maintain the value of your Kenmore range hood with a Sears Maintenance Agreement. Sears range hoods as designed, manufactures and tested for years of dependable operation. Yet, any modern appliance may require service from time to time.
Sears maintenance Agreement
Eliminates large or small repair bills resulting from normal use. Allows for as many service calls as required.
Provides for service by professionnal
This Maintenance Agreement does not cover original installation, reinstallation or damage resulting from external causes such as acts of abuse, theft, fire, flood, wind, lightning, freezing, power failure, power reduction, etc.
SEARS CANADA INC.
222 Jarvis Street, Toronto, Ontario, Canada M5B 2B8
| SAFETY INSTRUCTIONS |
| ! INTENDED FOR DOMESTIC COOKING ONLY ! |
WARNING | WARNING |
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address listed in the warranty.
2.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.
3.Installation work and electrical wiring must be done by qualified personnel in accordance with all applicable codes and standards, including
4.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
5.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
6.Do not use this range hood with any additional solid state speed control device.
7.Ducted fans must always be vented to the outdoors.
8.To reduce the risk of fire, use only metal ductwork.
9.When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
10.This unit must be grounded. To provide protection against electric shock, connect to properly grounded outlets only.
11.Inspect ducting at least every 12 months or after every range top fire in order to detect any risky conditions.
12.When applicable local regulations comprise more restrictive installation and/or certification requirements, the aformentioned requirements prevail on those of this document and the installer agrees to conform to these at his own expenses.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1.Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
2.Always turn hood ON when cooking at high heat or when flambeing food (i.e.: Crêpes Suzette, Cherries Jubilee, Peppercorn Beef Flambé).
3.Clean ventilating fan frequently. Grease should not be allowed to accumulate on fan or filters.
4.Use proper pan size. Always use cookware appropriate for the
size of the surface element. | 2 |
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
1.SMOTHER FLAMES with a
EVACUATE AND CALL THE FIRE DEPARTMENT.
2.NEVER PICK UP A FLAMING PAN - You may be burned.
3.DO NOT USE WATER, including wet dishcloths or towels - This could cause a violent steam explosion.
4.Use an extinguisher ONLY if:
A.You know you have a Class ABC extinguisher and you already know how to operate it.
B.The fire is small and contained in the area where it started.
C.The fire department is being called.
D.You can fight the fire with your back to an exit.
*Based on “Kitchen Fire Safety Tips” published by NFPA.
CAUTION 
!
1.For indoor use only.
2.For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
3.To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.
4.Your hood motor has a thermal overload which will automatically shut off the motor if it becomes overheated. The motor will restart when it cools down. If the motor continues to shut off and restart, have the hood serviced.
5.For best capture of cooking impurities, the bottom of the hood should be a minimum of 24” and a maximum of 30” above the cooking surface.
6.Two installers are recommended because of the large size and weight of this hood.
7.To reduce the risk of fire and to properly exhaust air on a ducted installation, be sure to duct air outside. Do not exhaust air into spaces within walls or ceiling or into attics, crawl spaces, or garage.
8.This product is equipped with a thermostat which may start blower automatically. To reduce the risk of injury and to prevent power from being switch on accidentally, switch power off at service panel and lock or tag service panel.
9.Because of the high exhausting capacity of this hood, you should make sure enough air is entering the house to replace exhausted air. Open a window close to or in the kitchen.
10.To reduce the risk of fire and electric shock, the Kenmore Elite hood should only be installed with its own
11.Please read specification label on product for further information and requirements.