Kenmore 31133, 31130 installation manual Hood using metal foil duct tape, fits easily in the duct

Page 10

PREPARE THE HOOD

NOTE

The following instructions are for the horizontal installation only. For a vertical installation, go to the “Install the hood” section on page 11.

These Kenmore Elite Series range hoods are factory shipped with the blower mounted for a vertical discharge configuration. For a horizontal discharge configuration, disassemble the blower from the inner top of the hood (see illustrations below). It will be assembled to the inner back of the hood once the hood is mounted on the wall.

3. Uplug the blower.

HE0085

4.Using a 5/16” socket, or a Robertson or a Phillips no. 2 screwdriver, remove all blower mounting screws from the inner top of the hood. Set aside the blower and its screws.

LEFT SIDE MOUNTING

SCREW LOCATION

RIGHT SIDE

MOUNTING SCREW

LOCATION

HD0385

HD0386

NOTE

If this hood replaces another one, please note that the location of the air exhaust can vary from one manufacturer to another. In order to ease a retrofit installation, the horizontal discharge may be positioned on higher OR on lower back of the hood.

5.According to your needs, the adapter/damper can be installed to the higer or lower back discharge using the upper screw holes on each side of the adapter/damper. See illustrations beside.

1

2

HJ0040

 

6. Secure the adapter/damper to the back of the hood using 2 no. 8 x 3/8” screws (included). Seal the adapter/damper to the

hood using metal foil duct tape.

NOTE

The wall ducting must be properly prepared to receive the adapter. Before performing the installation, make sure the adapter

fits easily in the duct.

10

Image 10
Contents Range Hood Warranty Table of ContentsSafety Instructions Cleaning OperationTools Needed for Hood Installation Parts Included with HoodWarranty Range Hood System15-ft. w/o damper Equivalent Duct Length ChartEquivalent length Equivalent length Ft -ft. w/o damperSelect Installation Type 29½Wiring Installation Grounding InstructionsRemove grease filters by lifting the metal latch tab Prepare the HoodLay the hood on its back on a table HoodHood using metal foil duct tape fits easily in the ductInstall the Hood Finalize the Installation Installing Grease Filters Changing Light Bulbs13.83 X 13.83 SET Service Parts120 V, 50 W, GU10 Parts BAG 5 no X 1½