Kenmore 31130, 31133 installation manual Installing Grease Filters, Changing Light Bulbs

Page 13

FINALIZE THE INSTALLATION

3.

Slide up the upper flue until it is aligned with its mounting

 

bracket. The bracket must be inside the flue. Secure

 

the upper flue to its bracket using 2 no. 8 x 3/8” screws

 

(included). See illustration beside.

 

NOTE

 

Duct not shown in illustration to ease understanding.

4.

Remove protective plastic film covering the upper flue.

UPPER FLUE MOUNTING BRACKET

FRONT VIEW

UPPER

FLUE

HO0140

Warranty

Safety

INSTALLING GREASE FILTERS

Rest rear filters edge on filter springs (A) in the range hood. Using metal latch tab, tilt up the filters into position. Make sure filter tabs (B) are securely engaged in range hood front edge after installation.

A

HD0393

B

CHANGING LIGHT BULBS

!WARNING: In order to prevent the risk of personal injury, do not install a lamp identified for use only in enclosed fixtures.

This range hood must use 2 shielded halogen lamps (120 V, 50 W PAR16 with GU10 base), included.

Refer to page 4 for ordering information.

!WARNING:them. In order to prevent the risk of personal injury, the halogen lamps must cool down before removing

Operation

Cleaning

Installation

1.

To remove lamps, gently push upwards and turn

 

counterclockwise to disengage bulb leads from their

 

grooves.

 

NOTE

 

If need be, use a rubber dishwashing glove to add grip when

 

removing the bulb.

2.

Install the new lamps by placing the bulb leads into their

 

grooves in the socket.

3. Gently push upwards and turn clockwise until secure.

1

2

3

HO0089

Service Parts

13

Image 13
Contents Range Hood Warranty Table of ContentsSafety Instructions Operation CleaningParts Included with Hood Tools Needed for Hood InstallationRange Hood System WarrantyEquivalent length Equivalent Duct Length Chart15-ft. w/o damper Equivalent length Ft -ft. w/o damper29½ Select Installation TypeGrounding Instructions Wiring InstallationLay the hood on its back on a table Prepare the HoodRemove grease filters by lifting the metal latch tab Hoodfits easily in the duct Hood using metal foil duct tapeInstall the Hood Finalize the Installation Changing Light Bulbs Installing Grease Filters120 V, 50 W, GU10 Service Parts13.83 X 13.83 SET Parts BAG 5 no X 1½