Precision Power DCX 800.5 manual QBASS/QBASS Plus Specifications, TOOLS/PARTS for Installation

Page 7

QBASS/QBASS PLUS SPECIFICATIONS

QBASSTM (DCX 300.4)

Up to 18dB of boost centered at 40Hz, with a Q-factor of 2.

QBASS PLUSTM (DCX 600.4, 1000.4, 800.5)

Up to 18dB of boost with selectable center frequency at 30Hz, 36Hz,

44Hz or 60Hz, with a Q-factor of 2.

Optional QBASS REMOTETM (DCX 600.4, 1000.4, 800.5)

This boost control can be mounted in the dash and will supersede the boost control on the amplifier endplate.

TOOLS/PARTS FOR INSTALLATION

NOTE: TOOLS ARE NOT SUPPLIED.

Small flat blade screwdriver

Phillips screwdriver (#2 or medium sized)

Wire cutters

Wire strippers

4 - #6 round head screws, and 1 - #8 sheet metal screw. (or nut, bolt, flat washer, star washer) (see details)

2 - Ring connectors (large enough to accommodate your method of grounding)

In-line fuse or circuit breaker Power and ground wire Speaker wire - 12-16 gauge

Grommets (sized to work with the power wire you plan to use in your installation)

Tube of silicone sealant

6

Image 7

Contents Amplifier Models Table of Contents Congratulations ServiceSpecifications FeaturesFuse Requirements Qbass PlustmAmplifier Status Leds TOOLS/PARTS for Installation QBASS/QBASS Plus SpecificationsWiring Page Charging System Ground WiringCurrent Draw Power Lock Connectors Power Wire SizeAmplifier Bridging Mixed Mono Output DCX Front Panel DCX 300.4 Front Plate DiagramDCX 300.4 END Plate Diagram Front HP/LP/FULL Switch Select the desired crossover Page DCX 800.5 Front Plate Diagram Page Source Headunit InputsDCX 300.4, 600.4, 1000.4 Block Diagram DCX 800.5 Block Diagram Qbass Advanced Instrumentation InputTC-X Crossover Qbass PlusDCX 300.4/600.4/1000.4 Crossover Detent Chart Forced AIR Thermal Management Adjusting Input GainInput Combine High Mass Internal HeatsinkAP-IV Protection Circuit Opposite Channel Same Channel Limited TWO Year Consumer Warranty