Precision Power DCX 300.4, DCX 800.5, DCX 1000.4 guide

same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inch of insulation. Locate the speaker/remote turn-on PowerLockTM connector. Loosen the outer screws on the underside of the connector. Insert the speaker leads into the end. Check to be sure you've maintained proper polarity before securing each wire, and plug the PowerLockTM into the amplifier.

Note: The power connector is inserted into the amplifier with the wire clamping screws in the up position as shown below.

For the rear channels, locate the four terminal speaker PowerLockTM connector. (For DCX 800.5, the 5th channel also uses a four terminal PowerLockTM connector.) On 4 and 5 channel DCX amplifiers, all speaker PowerLockTM plug into the amplifier with the screws facing up. Loosen the screws on the top of the blocks and insert the stripped ends of the speaker wires into the end. Double check polarity, secure each wire by tightening the screws, and plug the PowerLockTM connector into the amplifier with the screws on top.