Kenmore How to Remove a Oven Door: Step-by-Step Guide for Models
Page 20

Care and Cleaning

Removing and Replacing the Oven Door

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To remove the oven door:

1.Open oven door completely, horizontal with floor (See Figure 23).

2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely toward the oven door (See Figure 24). A tool such as a small flat-blade screwdriver may be required.

3.Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (See Figure 25).

4.Close the door to approximately 10 degrees from the door frame (See Figure 25).

5.Lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Figure 25).

To Replace Oven Door:

1.Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (See Figure 25).

2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Figure 25 and Figure 26). The hook of the hinge arms must be fully seated onto the roller pins.

3.Fully open the oven door, horizontal with floor (See Figure 23).

4.Push the door hinge locks up toward and into the oven frame on both left and right oven door hinges to the locked position (See Figure 24).

5.Close the oven door.

Important:

Special Door Care Instructions - Most oven doors contain glass that can break. Do not close the oven door until all the oven racks are fully in place. Do not hit the glass with pots, pans, or any other object. Scratching, hitting, jarring, or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

Oven door

hinge

locations

Figure 23: Door hinge location

 

 

K

 

C

O

 

L

 

 

Figure 24: Door hinge locks

about 10°

oven door

hinge

Figure 25: Holding door for removal

roller

pin

hinge

arm

Figure 26: Replacement and location of hinge arm and roller pin

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Electric Built-In Oven Table of Contents Important Safety Instructions Save these instructions for future referenceImportant Safety Instructions Important Instructions for Cleaning Your Oven For models factory-equipped with a power For ovens to be wired into a junction boxBefore Setting Oven Controls Oven vent locationDo not block oven vent Air circulation in the ovenOven Control Features Minimum and Maximum Control SettingsMinimum and maximum control settings Feature Oven ControlsSetting the Clock Setting TimerSetting 12 or 24 Hour Display Mode Add 1 MinuteSetting Oven Lockout Changing Oven Temperature DisplaySetting Silent or Audible Control Mode Radiant Bake Rack Positions Setting BakeSetting Cook Time To set Warm & Hold Setting Delay StartWarm & Hold Setting Broil Setting Cook Time in minutes1st side Home 1-800-469-4663 and order broiler pan kitAdjusting Oven Temperatures Restoring Factory Default SettingsTo restore oven control to factory default settings Operating Oven LightsSAb Important note To turn off the Sabbath feature PressPress to activate Self Clean Self CleanRead Before Starting Self Clean Setting Delay Start Self Clean Press Delay StartPress Self Clean If it becomes necessary to stop Self Clean when activeSurface Type Recommendation Care and CleaningCleaning Various Parts of Your Oven Care and Cleaning Removing and Replacing the Oven DoorTo remove the oven door To Replace Oven DoorReplacing the oven light To replace the oven interior light bulbOven Baking Baking Problems and Solutions Causes CorrectionsBefore You Call Before You Call Solutions to Common ProblemsProblem Solution Before You Call
Top Page Image Contents