Precision Power A1000/2, A500/2, A800/2 manual END Plate Diagram

Page 15

QBass frequency control adjustment.

12.RCA Outputs: RCA outputs provide HP/LP/FULL 30-4kHz signal to another amplifier.

END PLATE DIAGRAM

+18 0

QBASS

REMOTE

QBASS

1

2

3

4

1.Cooling Plenums: Maintain a minimum 2” clearance around cooling plenums for proper amplifier cooling.

2.Power/Ground PowerLockTM: Connect your power and ground to this Power/Ground PowerLockTM connector.

Note: Item descriptions 3 and 4 only apply to the A800/2 and A100/2 amplifiers.

3.QBASS REMOTETM: Plug in the data cable from the optional QBASS REMOTETM dash mounted level control here. (The remote level control will bypass the amplifier’s on board QBASSTM control.

4.QBASSTM Level Control: Controls bass boost, centered at 40Hz with up to 18dB of boost. On the A500/2 this adjustment is on the control panel (see previous figure).

14

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Amplifier Models Table of Contents Service FeaturesCongratulations WHAT’S Included CEA SpecificationsGeneral Specifications SpecificationsLength Width Height Amplifier Status Leds Wiring TOOLS/PARTS for InstallationPage Ground Wiring PowerlocktmCurrent Draw Charging SystemPower Wire Size Powerlock Connectors 1211 Front Plate DiagramEND Plate Diagram Advanced Instrumentation Input InputsQbass Plustm Qbass Plus SpecificationsQbass PLUS/QBASS Remote TC-X Crossover A500/2, A800/2, A1000/2Crossover Detent Chart Adjusting Input Gain High Mass Internal HeatsinkAP-IV Protection Circuit Opposite Channel Same Channel Limited TWO Year Consumer Warranty
Top Page Image Contents