Precision Power A1000/2, A500/2, A800/2 manual

Page 9

Note: The cables running from the battery to the rear of the car should be installed on the side of the car opposite to the antenna.

When using 16 gauge wire or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inch of insulation. Locate the speaker/remote turn- on PowerLockTM connector. Using a hex wrench loosen the screws on the upperside of the connector. Insert the speaker leads into the end and secure with the hex wrench. Check to be sure you've maintained proper polarity before securing each wire.

8

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Amplifier Models Table of Contents Service FeaturesCongratulations WHAT’S Included CEA SpecificationsGeneral Specifications SpecificationsLength Width Height Amplifier Status Leds Wiring TOOLS/PARTS for InstallationPage Ground Wiring PowerlocktmCurrent Draw Charging SystemPower Wire Size Powerlock Connectors 1211 Front Plate DiagramEND Plate Diagram Advanced Instrumentation Input InputsQbass Plustm Qbass Plus SpecificationsQbass PLUS/QBASS Remote TC-X Crossover A500/2, A800/2, A1000/2Crossover Detent Chart Adjusting Input Gain High Mass Internal HeatsinkAP-IV Protection Circuit Opposite Channel Same Channel Limited TWO Year Consumer Warranty
Top Page Image Contents