OPERATION
HOW TO STOP THE EDGER
1.Move the clutch lever back to the DIS-
ENGAGED position. Then, move the throttle control to the STOP position. See Figure 7.
EDGER unattended while the
_1 WARNING: Never leave the engine is running. Always dis-
engage the cutting blade and stop the
engine.
HOW TO USE |
|
| ||
THE THROTTLE | CONTROL | Throttle | ||
|
|
|
| |
1. | During | normal use, run the engine at full | ControI | |
| ||||
| speed. |
|
|
|
2. | Move | the throttle | control up to increase |
|
engine speed, or down to decrease en- gine speed (see Figure 7).
Clutch Lever
HOW TO USE
THE PRIMER BUTTON
When starting a cold engine, push the prim- er button five times (see Figure 8). Wait approximately two seconds between each push.
IMPORTANT: When starting a warm engine, do not use the primer button.
_'_Pri_mer Button
J | Figure 8 |
|
HOW TO USE
THE CLUTCH LEVER
Clutch Lever
1.Start the engine.
2.To engage the cutting blade, move the clutch lever forward (see Figure g).
3.Select the edging depth you need. There are five selections down to approximate- ly
NOTE: For deep edging, first cut at shallow depths. Then, cut at greater depths until
the desired depth is obtained.
Figure 9
F_OO1102M11