SERVICE AND ADJUSTMENT
HOW TO REMOVE THE BELT
The belt made of a special compound, if the belt becomes worn or breaks, replace the belt with an original equipment belt.
1.Disconnect the spark plug wire from the spark plug.
2.Pull the clutch lever back to release the tension from the belt.
3.Remove the two screws and spacers from the top of the engine pulley cover. Remove the engine pulley cover (see Figure 18).
4.Loosen, do not remove, the screw that holds the belt guide. Then, move the belt guide away from the belt.
5.Remove the two screws from the belt guard (see Figure 19).
6.Remove the oid belt from the engine and quill assembly pulleys. Replace with an original equipment belt.
7.To install a new belt, reverse the above steps.
@
Belt Guard
_.._ Screw
Figure 19
Screws | Figure 18 |