Cancel/Drain
To change a cycle:
o During the first two minutes of operation while filling, simply select a new cycle.
OR
i...,.i | . n.iH, | i . |
Automatic Preprogramming
Any option can be automatically preprogrammed by pressing and holding the desired option pad. The pad will beep when you first press it, then beep a second time while you continue to press ito Release the pad after the second beep. The option will automatically be chosen whenever you select a cycle with which the option normally works. To turn off a preprogrammed option, press and release the option pad, then press and hold the option pad until the pad beeps a second time..
o After the first two minutes, press Cancel/Drain, wait two minutes, and select a new cycle. (Remember to add detergent if the dishwasher has already gone through the wash portion of the cycle,)
Water Heat
Use this option when washing heavily soiled dishes. When you select Water Heat, the main wash will delay until the water heats to 135°F (57°C). As water heats, washing action will continue and the Water Heat light will glow; however, the electronic time display will pause.
o The Pots Pans cycle automatically uses Water Heat. o Selecting the Water Heat option will not cause water to be heated during Quick Rinse or China Ught cycle&
='t
!
;i
;4
:2:)::
!
No Heat Dry
Use this option to dry dishes in room temperature air and save energy When you select No Heat Dry, drying will take longer than heat drying, and water spotting can occur.. It is important to use rinse agent when selecting this option°
=Use this option when you do not plan to unload the dishwasher for several hours.
Sani Rinse
Sani Rinse is available in Pots Pans, Normal Wash, and Water Miser cycles.. When this option is selected, water for the final rinse is heated to ensure a high temperature, sanitary rinse. The cycle time will be extended until the water reaches the proper tempera-
ture. The Water Heat light glows and washing action continues while the water heats.. The Sani
Complete light glows at the end of the cycle indicating a high temperature, sanitary rinse was completed.
Cancel/Drain
When this option is selected, the dishwasher will stop and any water in it wilt drain. Draining will take about two minutes° When draining is complete, all signals will turn off. You may then select a new cycle, if you wish..
i
NOTE: A flashing Sani Complete light indicates that a high temperature, sanitary rinse was not completed, The Sani Complete light will flash at the end of the cycle if the dishwasher door is opened, power fails, or water heating is not completed during the final rinse, You may need to turn your water heater temperature up so water is at least 120°F (49°C) as it enters the dishwasher,
:;t;
i !i
%¸¸¸!