LSQT1174ENG.book 12 ページ ２００７年１月２９日 月曜日 午後１時２８分
Before using
Quick start
When quick start is on the battery power is still being consumed, even when the LCD monitor and the viewfinder are closed.
The camera will resume recording/pause mode about 1.7 seconds after the LCD monitor or the viewfinder is reopened.
≥Please note in quick start mode approximately half the pause recording power is being consumed. Using quick start mode will reduce the battery recording/playback time.
≥This is only activated in the following cases. ≥While using the battery
A tape is inserted, while the Tape Recording Mode is set.
≥While using the AC adaptor
Quick Start can be used even if a tape is not inserted.
≥Set to Tape Recording Mode.
1Set [SETUP] >> [QUICK START] >> [ON].
2While the [OFF/ON] switch is still set to [ON], close the LCD monitor and retract the viewfinder.
OFF
ON 
≥The status indicator lights green and the unit goes into quick start standby mode.
≥The movie camera will not go into quick start standby unless the LCD monitor is closed and the viewfinder is retracted.
3Open the LCD monitor or extend the viewfinder.
OFF
ON 
≥The status indicator lights red and the camera is put into recording pause approx.
1.7 seconds after it is turned on.
ªTo cancel Quick Start
1Set [SETUP] >> [QUICK START] >> [OFF].
≥If the [OFF/ON] switch is set to [OFF] while the unit is in quick start standby, the power turns off.
≥If the standby continues for approx. 30 minutes, then the status indicator will go off and the camera will be completely turned off.
≥In the following cases, quick start is cancelled and the power turns off.
≥When the Mode dial is moved.
≥When the battery or AC adaptor is removed. ≥When the tape is removed while using the
battery in Tape Recording Mode.
≥When the camera is
≥If the power is turned on in quick start standby, the zoom magnification becomes 5k and the picture size may differ from what it was before quick start standby.
≥If [POWER SAVE]
12
LSQT1174
