Record mode
19
LSQT1174
Recording on a tapeRemove the lens cap. (-7-)
(When the camera is turned on with the lens cap
fitted, the automatic white balance adjustment
may not function properly. Please turn the camera
on after removing the lens cap.)
≥Set to Tape Recording Mode.
1Press the recording start/stop button to
start recording.
2Press the recording start/stop button again
to pause recording.
≥For the recording time on a tape, refer to -9-.
≥Carry out a recording check (-19-) to verify that
the image is recorded properly.
≥In order to find the unrecorded section, carry out
the blank search (-20-).
ªOn-screen display in the tape
recording mode
1) Recording time elapse
2) Remaining tape indication
ªConcerning the remaining tape time
indication on the screen
≥The remaining tape time is indicated in minutes.
(When it reaches less than 3 minutes, the
indication starts flashing.)
≥During a 15 seconds or shorter recording, the
remaining tape time indication may not be
displayed or the remaining tape time may not be
displayed correctly.
≥In some cases, the remaining tape time
indication may display remaining tape time that
is 2 to 3 minutes shorter than the actual
remaining tape time.
Recording check The last image recorded is played back for 2 to
3 seconds. After checking, the camera will be set
to a recording pause.
≥Set to Tape Recording Mode.
1Press the joystick to display the icon during
the recording pause. Move the joystick
down until icon 1 appears.
2Move the joystick left to select the
recording check icon [ ].
≥The [RECORDING CHECK STARTED]
indication appears on the screen of the movie
camera.
;
1)
2)
1
LSQT1174ENG.book 19 ページ 2007年1月29日 月曜日 午後1時28分