English
5. | Press TEST again to stop the test tone. | TEST | |
4 | |||
|
| ||
6. | Press EFFECT to select an effect | EFFECT | |
| level you want. | 7/P |
•Each time you press the button, the effect level changes as follows:
DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3
DSP EFFECT 5 | DSP EFFECT 4 |
As the number increases, JVC Theater Surround becomes stronger.
On the front panel:
You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.
Activating the DSP Modes
You can use only one DSP mode at a time. When a DSP mode is activated, another DSP mode is canceled if in use.
For Dolby Pro Logic, Dolby Digital, DTS Digital Surround and MPEG Multichannel
1.Press SURROUND ON/OFF so that the lamp on the front panel button lights up.
•Each time you press the button, the Dolby/DTS/MPEG Surround turns on and off alternately.
SURROUND ON/OFF
| SURROUND |
| ON/OFF |
On the front panel | On the remote control |
1.Press DSP MODE repeatedly until “THEATER” appears on the
display.
The Ù PRO LOGIC and DSP indicators also light up on the display.
2.Adjust the speaker output levels.
1)Press (BALANCE/) SURROUND ADJUST repeatedly until one of the indications appears on the display. “CENTER LEVEL”:
To adjust the center speaker level. “REAR L LEVEL”:
To adjust the left rear speaker level. “REAR R LEVEL”:
To adjust the right rear speaker level.
2)Turn MULTI JOG to adjust the selected speaker output level (from
3)Repeat 1) and 2) to adjust the other speaker output levels.
DSP MODE
BALANCE/SURROUND
ADJUST
MULTI JOG
2. Select and play a sound source.
• To enjoy Dolby Pro Logic, play back a software encoded with
Dolby Surround and labeled with mark.
•To enjoy Dolby Digital, play back a software encoded with Dolby Digital and labeled with D I G I T A L mark.
•To enjoy DTS Digital Surround, play back a software encoded
with DTS Digital Surround and labeled with mark.
•To enjoy MPEG Multichannel, play back a software encoded
with MPEG Multichannel and labeled with mark.
To cancel the Dolby/DTS/MPEG Surround mode
Press SURROUND ON/OFF again so that the lamp on the front panel button goes off. (“SURROUND OFF” appears on the display.)
SURROUND ON/OFF
SURROUND |
ON/OFF |
3.Adjust the effect level.
1)Press (BALANCE/) SURROUND ADJUST repeatedly until “DSP EFFECT” appears on the display. The display changes to show the current setting.
2)Turn MULTI JOG to select the effect level.
As you turn it, the effect level changes as follows:
BALANCE/SURROUND
ADJUST
MULTI JOG
On the front panel | On the remote control |
DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3
DSP EFFECT 5 | DSP EFFECT 4 |
As the number increases, JVC Theater Surround becomes stronger.
27