Reinstalling the Refrigerator Door
I_ Right Door
1.Lower the door onto middle hinge pin (9).
2.Fit top hinge (7) over hinge lever latch (8) and into place. Insert hinge lever (6) under lever latch. Rotate lever counterclockwise to secure hinge.
3.Install the grounding screw (5) and connect wire harnesses (4).
4.Hook tab on door switch side of cover under edge of wire opening in cabinet top. Position cover (2) into place. Insert and tighten cover screw (1).
I_ Left Door
1.Lower the door onto middle hinge pin (9).
2.Fit top hinge (7) over hinge lever latch (8) and into place. Insert hinge lever (6) under lever latch. Rotate lever clockwise to secure hinge.
3.Install the grounding screw (5) and connect the three wire harnesses (4).
4.Push the water supply tube into the hole on the top case and pull it out on the backplate.
5.Insert the water supply tube (3) into the connector tube until you see only one scale mark. (Fully insert the tube over 5/8"(15mm)).
6.Hook tab on door switch side of cover (2) under edge of wire opening in cabinet top. Position cover into place. Insert and tighten cover screw (1).
CAUTION
Collet
Tube
Insert Line
Clip
After inserting, pull the tube to ascertain that it is secure and
assemble the clip.
Correct
Incorrect
16