Precision Power DCX 300.2, DCX 500.2 manual Powerlock Connectors

Page 13

POWERLOCK CONNECTORS

Once you have run both the power and ground wires, then connect the cables to the amplifier. Cut off excess wire, and using wire strippers, strip the ends of the power and ground cables approximately 1/4 inch. Locate the PowerLockTM power and ground connector (supplied). With a small flat blade screwdriver, loosen the screws before attempting to insert the cable wires. Insert the wires into the appropriate hole, and tighten the screws. Once the wires are secure, the PowerLockTM may be plugged into the amplifier. The Power/Ground PowerLockTM will accommodate 4 gauge wire for the DCX 300.2, and DCX 500.2.

12

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Amplifier Models Table of Contents Congratulations ServiceQbass Plus Specifications FeaturesPower Ratings Specifications35 a Amplifier Status Leds Wiring TOOLS/PARTS for InstallationPage Charging System Ground WiringCurrent Draw Power Wire Size Powerlock Connectors DCX 300.2, DCX 500.2 Front Plate Diagram DCX 300.2, DCX 500.2 END Plate Diagram Advanced Instrumentation Input InputsQbass PLUS/QBASS Remote TC-X Crossover DCX 300.2/500.2Crossover Detent Chart High Mass Internal Heatsink Adjusting Input GainAP-IV Protection Circuit Opposite Channel Same Channel Limited TWO Year Consumer Warranty
Top Page Image Contents