Precision Power DCX 500.2, DCX 300.2 manual TOOLS/PARTS for Installation, Wiring

Page 8

TOOLS/PARTS FOR INSTALLATION

NOTE: TOOLS ARE NOT SUPPLIED.

Small flat blade screwdriver

Phillips screwdriver (#2 or medium sized) Wire cutters

Wire strippers

4 - #6 round head screws, and 1 - #8 sheet metal screw. (or nut, bolt, flat washer, star washer) (see details)

2 - Ring connectors (large enough to accommodate your method of grounding)

In-line fuse or circuit breaker Power and ground wire Speaker wire - 12-16 gauge

Grommets (sized to work with the power wire you plan to use in your installation)

Tube of silicone sealant

WIRING

Before beginning, disconnect the negative (-) terminal of the battery prior to connecting the amplifier to the positive (+) 12V terminal to prevent a short to ground and potential damage to wiring and equipment. Some vehicle radios have an anti-theft feature where when the radio is removed from 12V the radio will no longer function and must be code reset.

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Amplifier Models Table of Contents Service CongratulationsFeatures Qbass Plus SpecificationsSpecifications Power Ratings35 a Amplifier Status Leds TOOLS/PARTS for Installation WiringPage Ground Wiring Charging SystemCurrent Draw Power Wire Size Powerlock Connectors DCX 300.2, DCX 500.2 Front Plate Diagram DCX 300.2, DCX 500.2 END Plate Diagram Inputs Advanced Instrumentation InputQbass PLUS/QBASS Remote DCX 300.2/500.2 TC-X CrossoverCrossover Detent Chart AP-IV Protection Circuit Adjusting Input GainHigh Mass Internal Heatsink Opposite Channel Same Channel Limited TWO Year Consumer Warranty
Top Page Image Contents