Precision Power DCX 300.2, DCX 500.2 manual

Page 9

Note: The cables running from the battery to the rear of the car should be installed on the side of the car opposite to the antenna.

When using 16 gauge wire or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inch of insulation. Locate the speaker/remote turn-on PowerLockTM connector. Loosen the outer screws on the underside of the connector. Insert the speaker leads into the end. Check to be sure you've maintained proper polarity before securing each wire, and plug the PowerLockTM into the amplifier.

8

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Amplifier Models Table of Contents Congratulations ServiceQbass Plus Specifications FeaturesPower Ratings Specifications35 a Amplifier Status Leds Wiring TOOLS/PARTS for InstallationPage Charging System Ground WiringCurrent Draw Power Wire Size Powerlock Connectors DCX 300.2, DCX 500.2 Front Plate Diagram DCX 300.2, DCX 500.2 END Plate Diagram Advanced Instrumentation Input InputsQbass PLUS/QBASS Remote TC-X Crossover DCX 300.2/500.2Crossover Detent Chart Adjusting Input Gain High Mass Internal HeatsinkAP-IV Protection Circuit Opposite Channel Same Channel Limited TWO Year Consumer Warranty
Top Page Image Contents