Kenmore 795.7109 manual Base Grille iNSTALLATiON, Prior to USE, To remove the base grllle

Page 10

BASE GRILLE iNSTALLATiON

To remove the base grllle:

I)Open the Freezer Drawer. (Drawer not shown for clarity.)

2)Once the drawer is open, and there is sufficient clearance, remove the screws on the top of the cover.

To replace the base grllle:

Place the cover into position and then insert and tighten the screws.

PRIOR TO USE

1.Clean your refrigerator thoroughly and wipe off all dust that accumulated during shipping.

2.Install accessories such as ice cube bin, drawers, shelves, etc., in their proper places. They are packed together to prevent possible damage during shipment.

oAllow your refrigerator to run for at least two to three hours before putting food in it. Check the flow of cold air in the freezer compartment to ensure proper cooling. Your refrigerator is now ready for use.

iNSTALLATiON (continued)

lo To avoid noise and vibration, the unit must be leveled and installed on a solidly constructed floor. If required, adjust the leveling legs to compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. Leveling legs can be turned easily by tipping the cabinet slightly. Turn the leveling legs to the left to raise the unit or to the right to lower it. (See LEVELING AND DOOR ALIGNMENT.)

NOTE: Installing on carpeting, soft tile surfaces,

a platform or weakly supported structure is not recommended.

oInstall this appliance in an area where the temperature is between 55°F (13°C) and 110°F (43°C). If the temperature around the appliance is too low or high, cooling ability may be adversely affected.

o Select a place where a water supply can be easily connected for the automatic Jcemaken

NOTE: The water pressure must be between 20 and 120 psi on models without a water filter and between 40 and 120 psi on models with a water filter.

oToo small of a distance from adjacent items may result in lowered freezing capability and increased electricity consumption charges. Allow at least 24 inches (61 cm) in front of the refrigerator to open the doors and at least 2 inches (5.08 cm) between the back of the refrigerator and the walt.

iNSTALLATiON

The refrigerator should always be plugged into its own individual properly grounded electrical outlet rated for 115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes. This provides the best performance and also prevents overloading house wiring circuits which could cause a fire hazard from overheated wires. It is recommended that a separate circuit serving only this appliance be provided.

Shock Hazard:

To reduce the risk of electric shock, do not instalt the refrigerator in a wet or damp area.

10

MFL62184418

nE]E]E]E].indd 10

2011.4.7

11:53:37 AM

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Use & Care Guide Manual de Uso y Cuidado Guide dUfilisafion ef dEntretienElectrical Grounding SafetySection Protection Agreements Water FilterKenmore Limited Warranty Disclalmer of implled warranties llmltatian of remediesMaster Protection Agreements Basic Safety Precautions Before YOU Throw Away Your OLD Refrigerator Or FreezerTo Connect ELECTRiCiTY Electrical Shock Hazard USE of Extension CordsIceBin Excessive Weight Hazard Excessive Weight HazardTo remove the base grllle Base Grille iNSTALLATiONPrior to USE To replace the base grllleDoor Handle Removing Freezer Drawer Handle HOW to Remove Freezer Door HandleReplacing Freezer Drawer Handle To remove the left refrigerator door Removing and ReplacingTo remove the right refrigerator door Left Door HOW to Remove the Freezer Drawers Bottom Freezer DrawerHOW to iNSTALL the Freezer Drawers Top Freezer DrawerLeveling Leveling and Door AlignmentDoor Allgnment Dispenser Setting the ControlsAirflow Ultra iceDemo Mode For Store Use Only Door AlarmTemperature Mode Switch Function F =C Energy SaverMFL62184418 DDDDD.Jndd 2011.4.7 115417 AM Automatic Icemaker Normal Sounds YOU MAY Hear When YOU should SET the Icemaker Power Switch to OFF OAutomatic Icemaker Preparing for VacationEggs Store in the original wrappingMilk VegetablesWater Dispenser Dispenser PushAdjusting Shelves Cantilever Foldlng Shelf on some modelsGlide NServe Control Removing and installlng the humidity controlled crisperHUMiDiTY Controlled Crisper To remove and replace Glide NServeExtra iCE BiN Freezer SectionDairy BiN DurabaseWater Filter Water Filter Bypass PlugPerformance Data Sheet ReportMFL62184418 DDDDD.indd 2011.4.7 3722 PM Water Treatment Device Certificate Number Exterior General Cleaning TipsExplosion Hazard Door Liners and GasketsWhen YOU Move Light Bulb Replacement Power InterruptionsWhen YOU GO on Vacation Change Freezer Compartment Light BulbWhat YOU will Need Power drillWater Pressure Compression fitting Shutoff valve to connectInlet End Shut OFF the Main Water SupplyOutlet Connect the Tubing to the Refrigerator Start the IcemakerOperating Cooling40-120 Not coolingSection Supply valve SettingsSealed Supply lineICE & Water Doors are not closed completelySupply Water supply or the supply shutoffConnected As sulfur SeveralOperation Control will click whenSystem Parts & Features Managemylife

795.7109 specifications

The Kenmore 795.7109 refrigerator is a standout appliance in the realm of modern kitchen technology, combining innovative features and aesthetics to enhance any household. Known for its reliable performance and spacious design, this fridge brings together essential functionalities with cutting-edge technologies.

One of the main features of the Kenmore 795.7109 is its French door design, which not only offers a sleek and contemporary appearance but also maximizes access to stored items. With a generous capacity, it accommodates a large volume of food and beverages, making it an ideal choice for families or individuals who enjoy entertaining.

A significant technology incorporated into the Kenmore 795.7109 is the SmartSense temperature management system. This advanced feature uses multiple sensors to monitor and maintain optimal cooling conditions throughout the refrigerator and freezer compartments. By constantly adjusting temperatures in response to changes, the SmartSense system ensures food stays fresh for longer periods.

Another noteworthy aspect of the Kenmore 795.7109 is its energy efficiency. It is designed to meet stringent energy use guidelines, which helps reduce electricity bills while minimizing environmental impact. This makes it an eco-friendly choice for consumers who are conscious of energy consumption.

The refrigerator also includes a water and ice dispenser, providing convenient access to filtered water and fresh ice cubes. The dispenser is designed for easy use, allowing for quick filling of bottles and pitchers without the need to open the fridge. The interior features adjustable shelves and bins, providing customizable storage options to organize groceries effectively.

In addition to storage and efficiency features, the Kenmore 795.7109 is equipped with advanced filtration systems that ensure clean drinking water by removing impurities. This feature gives peace of mind to families, knowing that their drinking water is safe and tastes great.

Overall, the Kenmore 795.7109 refrigerator strikes a harmonious balance between functionality, technology, and style. Its array of features, such as SmartSense temperature management, energy efficiency, and convenient ice and water access, make it a valued addition to any kitchen. Whether for its spacious interior or its sophisticated design, it exemplifies quality and reliability in the world of home appliances.
Top Page Image Contents