Kenmore 795.7109 manual Water supply or the supply shutoff, Supply, Connected

Page 41

iCE & WATER

Icemaker

is not

Refrigerator

was

recently

installed or

making

ice.

icemaker

recently connected,

 

 

Icemaker

not

turned on.

 

 

 

The ice detecting sensor is obstructed.

 

 

The refrigerator is not connected to

 

 

a water supply or the supply shutoff:

 

 

valve is not turned on.

 

 

 

Icemaker shutoff: (arm or sensor)

 

 

obstructed.

 

 

 

 

 

 

Reverse osmosis

water filtration

 

 

system is connected to your cold

 

 

water

supply.

 

 

 

Not dispensing water.

New

installation

or water

line recently

connected.

The dispenser panel is locked.

The dispenser is not set for water dispensing,

Refrigerator or freezer doors are not closed properly,

Water filter has been recently removed or replaced.

Tubing connecting refrigerator to house supply valve is kinked.

The house water supply is not

connected, the valve is not turned on fully, or the valve is clogged.

41

it may take up to 24 hours for each compartment to reach the desired temperature and for the icemaker to begin making ice.

Locate the icemaker ON/OFF switch and confirm that it is in the ON (I) position.

Foreign substances or frost on the ice-detecting sensor can interrupt ice production. Make sure that the sensor area is clean at all times for proper operation.

Connect refrigerator to the water supply and turn the water shutoff: valve futty open.

If your icemaker is equipped with an ice shutoff: arm, make sure that the arm moves freely. If your icemaker is equipped with the electronic ice shutoff: sensor, make sure that there is a clear path between the two sensors.

Reverse osmosis filtration systems can reduce the water pressure below the minimum amount and result in icemaker issues. (Refer to the Water Pressure section.)

Dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air and contaminates from the system. Do not dispense the entire 2.5 gallon amount continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF.

Press and hold the Lock button for three seconds to unlock the control panel and dispenser.

The dispenser can be set for ice or water. Make certain that the control panel is set for the proper operation. Press the Water button on the control panel to dispense water.

Water will not dispense if any of the refrigerator doors are left open.

After the water filter is replaced, dispense 2.5 gallons

of water (flush for approximately 5 minutes) to remove trapped air and contaminates from the system. Do not dispense the entire 2.5 gallon amount continuously.

Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF.

The tubing can kink when the refrigerator is moved during installation or cleaning resulting in reduced water flow. Straighten or repair the water supply line and arrange it to prevent future kinks.

Connect refrigerator to the water supply and turn the water shutoff: valve fully open.

If the problem persists, it may be necessary to contact a plumber.

MFL62184418

DDDDD.indd

41

2011.4.7

11:54:42 AM

Image 41
Contents Manual de Uso y Cuidado Guide dUfilisafion ef dEntretien Use & Care GuideSection Protection Agreements SafetyElectrical Grounding Water FilterDisclalmer of implled warranties llmltatian of remedies Kenmore Limited WarrantyMaster Protection Agreements Basic Safety Precautions Or Freezer Before YOU Throw Away Your OLD RefrigeratorUSE of Extension Cords To Connect ELECTRiCiTY Electrical Shock HazardIceBin Excessive Weight Hazard Excessive Weight HazardPrior to USE Base Grille iNSTALLATiONTo remove the base grllle To replace the base grllleDoor Handle Replacing Freezer Drawer Handle HOW to Remove Freezer Door HandleRemoving Freezer Drawer Handle To remove the right refrigerator door Removing and ReplacingTo remove the left refrigerator door Left Door Bottom Freezer Drawer HOW to Remove the Freezer DrawersTop Freezer Drawer HOW to iNSTALL the Freezer DrawersDoor Allgnment Leveling and Door AlignmentLeveling Airflow Setting the ControlsDispenser Ultra iceTemperature Mode Switch Function F =C Door AlarmDemo Mode For Store Use Only Energy SaverMFL62184418 DDDDD.Jndd 2011.4.7 115417 AM Automatic Icemaker Automatic Icemaker When YOU should SET the Icemaker Power Switch to OFF ONormal Sounds YOU MAY Hear Preparing for VacationMilk Store in the original wrappingEggs VegetablesDispenser Push Water DispenserFoldlng Shelf on some models Adjusting Shelves CantileverHUMiDiTY Controlled Crisper Removing and installlng the humidity controlled crisperGlide NServe Control To remove and replace Glide NServeDairy BiN Freezer SectionExtra iCE BiN DurabaseWater Filter Bypass Plug Water FilterReport Performance Data SheetMFL62184418 DDDDD.indd 2011.4.7 3722 PM Water Treatment Device Certificate Number Explosion Hazard General Cleaning TipsExterior Door Liners and GasketsWhen YOU GO on Vacation Light Bulb Replacement Power InterruptionsWhen YOU Move Change Freezer Compartment Light BulbWater Pressure Power drillWhat YOU will Need Compression fitting Shutoff valve to connectOutlet Shut OFF the Main Water SupplyInlet End Start the Icemaker Connect the Tubing to the Refrigerator40-120 CoolingOperating Not coolingSection Sealed SettingsSupply valve Supply lineDoors are not closed completely ICE & WaterConnected Water supply or the supply shutoffSupply Several As sulfurSystem Control will click whenOperation Parts & Features Managemylife

795.7109 specifications

The Kenmore 795.7109 refrigerator is a standout appliance in the realm of modern kitchen technology, combining innovative features and aesthetics to enhance any household. Known for its reliable performance and spacious design, this fridge brings together essential functionalities with cutting-edge technologies.

One of the main features of the Kenmore 795.7109 is its French door design, which not only offers a sleek and contemporary appearance but also maximizes access to stored items. With a generous capacity, it accommodates a large volume of food and beverages, making it an ideal choice for families or individuals who enjoy entertaining.

A significant technology incorporated into the Kenmore 795.7109 is the SmartSense temperature management system. This advanced feature uses multiple sensors to monitor and maintain optimal cooling conditions throughout the refrigerator and freezer compartments. By constantly adjusting temperatures in response to changes, the SmartSense system ensures food stays fresh for longer periods.

Another noteworthy aspect of the Kenmore 795.7109 is its energy efficiency. It is designed to meet stringent energy use guidelines, which helps reduce electricity bills while minimizing environmental impact. This makes it an eco-friendly choice for consumers who are conscious of energy consumption.

The refrigerator also includes a water and ice dispenser, providing convenient access to filtered water and fresh ice cubes. The dispenser is designed for easy use, allowing for quick filling of bottles and pitchers without the need to open the fridge. The interior features adjustable shelves and bins, providing customizable storage options to organize groceries effectively.

In addition to storage and efficiency features, the Kenmore 795.7109 is equipped with advanced filtration systems that ensure clean drinking water by removing impurities. This feature gives peace of mind to families, knowing that their drinking water is safe and tastes great.

Overall, the Kenmore 795.7109 refrigerator strikes a harmonious balance between functionality, technology, and style. Its array of features, such as SmartSense temperature management, energy efficiency, and convenient ice and water access, make it a valued addition to any kitchen. Whether for its spacious interior or its sophisticated design, it exemplifies quality and reliability in the world of home appliances.