Maximum Ice Production (on some models): In maximum ice production, the ice maker should produce approximately 10 to 14 batches of ice in a
MAX.
To remove and replace freezer shelf ice bin (Style 1):
1.Pull the covering panel out from the bottom and then slide it back toward the rear.
2.Lift the wire shutoff arm so it clicks into the OFF (up) position. Ice can still be dispensed, but no more can be made.
3.Lift up the front of the storage bin and pull it out.
4.Replace the bin by pushing it in all the way or the dispenser will not work. Push the wire shutoff arm down to the ON
position to restart ice production. Make sure the door is closed tightly.
To turn the ice maker on/off (Style 2):
The ON/OFF switch is located on the top right side of the freezer compartment.
1.To turn the ice maker on, slide the control to the ON (left) position.
NOTE: Your ice maker has an automatic shutoff. The ice maker sensors will automatically stop ice production, but the control will remain in the ON (left) position.
2.To manually turn the ice maker off, slide the control to the OFF (right) position.
To remove and replace freezer door ice bucket (Style 2):
1.Place four fingers in bucket base opening and rest thumb on the release button.
2.Holding the base of the bucket with both hands, depress the release button and lift the bucket up and out. It is not necessary to turn the ice maker control to the OFF (right)
position. The ice maker will not produce ice without the bucket installed in the door.
2.Wash ice bin or bucket with a mild detergent, rinse well and dry thoroughly. Do not use harsh or abrasive cleaners or solvents.
REMEMBER:
•Allow 24 hours to produce the first batch of ice.
•Discard the first three batches of ice produced to avoid impurities that may be flushed out of the system.
•The quality of your ice will be only as good as the quality of the water supplied to your ice maker.
•Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.
•It is normal for the ice cubes to be attached at the corners. They will break apart easily.
•For Style 1 ice maker, do not force the wire shutoff arm up or down.
•Do not store anything on top of or in the ice maker or ice bin or bucket.
REFRIGERATOR
Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word "Accessory." Not all accessories will fit all models.
If you are interested in purchasing one of the accessories, please call the
section.
Important information to know about glass shelves and covers:
Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. For your protection, tempered glass is designed to shatter into many small,
Your model may have glass or wire shelves. Store similar foods together and adjust the shelves to fit different heights. This reduces the time the refrigerator door is open and saves energy.
Slide-out Shelves (on some models)
To remove and replace a shelf in a metal frame:
1. Pull the shelf forward to the stop. Tilt the front of the shelf up and lift it slightly as you pull the shelf from the frame.
To care for ice storage bin or bucket:
1.Empty the ice container. Use warm water to melt the ice if necessary.
NOTE: Never use anything sharp to break up the ice in the bin or bucket. This can cause damage to the ice container and the dispenser mechanism.
13