Kenmore 10651562104 manual Removing packaging materials, When Moving Your Refrigerator, II -- lil

Page 4

REFRIGERATOR

INSTALLATION

Excessive Weight Hazard

Use two or more people to move and install refrigerator,

Failure to do so can result in back or other injury,

Removing packaging materials

Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These

products can damage the surface of your refrigerator. For more information, see the "Refrigerator Safety" section.

When Moving Your Refrigerator:

Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it.

Do not wiggle or "walk" the refrigerator when trying to move it, as floor damage could occur.

Cleaning before use

After you remove all of the packaging materials, clean the inside of your refrigerator before using it. See the cleaning instructions in the "Refrigerator Care" section.

Important information to know about glass shelves and covers:

Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping.

For your protection, tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use special care when re- moving them to avoid impact from dropping.

_'_.-_ _ _ A¸_ o_e,

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from refrigerator,

Failure to do so can result in death, explosion, or fire,

To ensure proper ventilation for your refrigerator, allow for 1/2in. (1.25 cm) space on each side and at the top. When installing your refrigerator next to a fixed wall, leave 2 in. (5.08 cm) minimum on each side (depending on your model) to allow for the door to swing open. If your refrigerator has an ice maker, allow extra space at the back for the water line connections.

NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C).

___LJ__

/

//

/

1/2" (1.25 cm) /

II -- lil

/

/

u_

J

2" (5.08 cm) /

4

Image 4
Contents Sears Canada Inc., Toronto, Ontario, Canada M5B 2B8 Sears Roebuck Co., Hoffman Estates, IL 60179 U.S.A2220695 Contents Warranty Refrigerator Safety Before you throw away your old refrigerator or freezerRemoving packaging materials When Moving Your RefrigeratorII -- lil To remove the base grille Recommended grounding methodWater Dispenser Tubing Connection Handle Removal Optional Base Grille Bottom HingeDoor and Hinge Replacement StyleConnecting to Water Line Connecting to RefrigeratorDo S C and a ignment Supply Con eot sEnsu qng Refrigerator USECi cu atin Adjusting Rotary Controls Setting AdjustmentSw sd Nse rs Ice dispenserOnsome mode s Using the dispenser without the water filter Msk÷ a// d on!sge B n/BucketStyle 1 Behind the base grille filter Flushing the Water System After Replacing FilterRefrigerator Slide-out Shelves on some modelsMAX RememberOnsome mode Up Sh@fCnve tib/e getab e/Mest Ssper Cnvet bb @ge bb/Meat ContAn!B/£/e SS sezeMeat storage guide Humidity control locationRefrigerator Care Oan Do@ BnsDrop-in Door Rails Snap-onDoor Rails To remove and replace the railsAng ng t s L g st Bubs Refrigerator Control Panel LightUpper Freezer Light on some models Lower Freezer Light Beneath Ice Bin on some modelsOubleshooting MovingOff-taste, odor or gray color in the ice There is water in the defrost drain panIs the water line shutoff valve to the refrigerator turned Dispenser water is not cool enough Service Sears Installation ServiceU SAo Are the pans, shelves, bins, or baskets out of position?Water Certifications OanadaEPA Product DataMCL Your Home LE-FOYER Mc