There is water in the defrost drain pan

•Is a light bulb loose in the socket or burned out? See the "Changing the Light Bulb(s)" section.

There is water in the defrost drain pan

Is the refrigerator defrosting? The water will evaporate. It is normal for water to drip into the defrost pan.

Is it more humid than normal? When it is humid, expect that the water in the defrost pan will take longer to evaporate.

The motor seems to run too much

Is the room temperature hotter than normal? The motor will run longer under warm conditions. At normal room temperatures, expect your motor to run about 40% to 80% of the time. Under warmer conditions, it will run even more.

•Has a large amount of food just been added to the refrigerator?. Adding a large amount of food warms the refrigerator. The motor normally will run longer to cool the refrigerator back down.

•Are the doors opened often? The motor will run longer when this occurs. Conserve energy by getting all items out at one time, keeping food organized, and closing the door as soon as possible.

•Are the controls not set correctly for the surrounding conditions? Refer to the "Setting or Using the Controls" section.

Are the doors not closed completely? Close the doors

firmly. If they do not close completely, see "The doors will not close completely" later in this section.

Are the condenser coils dirty? This prevents air transfer and makes the motor work harder. Clean the condenser coils.

Refer to the "Cleaning" section.

Are the door gaskets not sealed all the way around? Contact a technician or other qualified person.

NOTE: Your new refrigerator will run longer than your old one due to its high-efficiency motor.

The refrigerator seems to make too much noise

•The sounds may be normal for your refrigerator. See the "Normal Sounds" section.

The ice maker is not producing ice or not enough ice

•Has the ice maker just been installed? Wait 72 hours for full ice production to begin. Once your refrigerator is cooled, the ice maker should produce 70 to 120 cubes every 24 hours.

Is the freezer temperature cold enough to produce ice? Wait 24 hours after ice maker hook-up for ice production. See the "Setting or Using the Controls" section.

Is the ice maker wire shutoff arm in the OFF (arm up) position (on some models)? Lower the wire shutoff arm to

the ON (arm down) position. See the "Ice Maker and Storage Bin/Bucket" section.

Is the ice maker switch in the OFF (right) position (on some models)? Move ice maker switch to the ON (left)

position. See the "Ice Maker and Storage Bin/Bucket" section.

Is the water line shutoff valve to the refrigerator turned

on? Turn on the water valve. See the "Water Supply Connection" section.

•Does the ice maker mold have water in it or has no ice been produced? Make sure your refrigerator has been connected to a water supply and the supply shutoff valve is turned on. See the "Water Supply Connection" section.

Is an ice cube jammed in the ice maker ejector arm? For models with an interior ice bin, remove the ice from the

ejector arm with a plastic utensil. For models with an ice bucket located on the freezer door, access the ice maker by depressing the ice sensor door on the upper left side of the freezer interior. While depressing the sensor door, lift the ice maker service door and remove the ice from the ejector with a plastic utensil. See the "Ice Maker and Storage Bin/Bucket" section.

•Has a large amount of ice just been removed? Allow 24 hours for ice maker to produce more ice.

•Are the controls set correctly? See the "Setting or Using the Controls" section.

Is there a water filter installed on the refrigerator? The filter may be clogged or installed incorrectly. Check the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging is not a problem, call a technician or other qualified person.

NOTE: If not due to any of the above, there may be a problem with the water line. Call for service.

Off-taste, odor or gray color in the ice

Are the plumbing connections new, causing discolored or off-flavored ice? Discard the first few batches of ice.

Have the ice cubes been stored too long? Throw old ice away and make a new supply.

Does the freezer and ice bin or bucket need to be

cleaned? See the "Cleaning" or "Ice Maker and Storage Bin/ Bucket" section.

•Has food in the freezer or refrigerator been wrapped properly? Use airtight, moisture-proof packaging to help prevent odor transfer to stored food.

•Does the water contain minerals (such as sulfur)? A filter may need to be installed to remove the minerals.

•Is there a water filter installed on the refrigerator? Gray or dark discoloration in ice indicates that the water filtration

system needs additional flushing. Run additional water through the water dispenser to flush the water filtration system more thoroughly (at least 2 to 3 gal. [8 to 12 L] or 6 to 7 minutes initially). Discard discolored ice.

The ice dispenser will not operate properly

Is the freezer door closed completely? Push the door firmly shut. If it will not shut all the way, see "The doors will not close completely" later in this section.

Is the ice bin or bucket installed correctly? For models with an interior ice bin, push the ice bin in all the way. If the ice bin does not go in all the way, it may not be put in straight.

Pull it out and try again. For models with an ice bucket located on the freezer door, the bucket should sit level. To remove the bucket, press the release button on the right side

of the bucket and lift straight up. Replace the bucket in the door making sure it is properly aligned and snapped securely into place. Refer to the "Ice Maker and Storage Bin/Bucket" section.

Has the wrong ice been added to the bin or bucket? Use only cubes produced by the current ice maker. If other cubes have been added, remove all cubes and check to see that none have become stuck in the delivery chute.