Remote receiver

Place the remote receiver inside your house but close to the pool side alarm unit and at a straight line of sight. DO NOT place the unit near large metal objects or large motors, such as a refrigerator, or washing machine. This will adversely affect the RF reception

Plug in the A/C adapter and the green LED will stay ON, indicating it is ready to receive signals.

Hit the RESET button located between the two LEDs, to reset the receiver. Each reset will disable the receiver for 10 seconds, allowing you enough time to go to the pool side alarm transmitter to reset it, or turn it off. During this 10 second timeframe, the red LED will flash every 1 second. If you do not reset the receiver, it will reset automatically in four minutes.

Remote Receiver Channel A/B select

The pool side alarm or other POOLEYE alarms RF (radio frequency) signal can be transmitted from the transmitter to the receiver inside the house by two different channels (A or B). All units are preset at channel A in the factory. However, if your alarm system interferes your neighborís alarm system, you may have to change them to channel B.

The remote receiver has a built in channel select switch, located inside the receiver box. Loosen the four screws and remove the battery door.You can find a slide switch at the corner that mark ìAîand ìBî. Push the switch handle from position ìAîto position ìBî.Make sure you do the same channel adjust on all your POOLEYE devices, including the pool side alarm transmitter. Check the RF link periodically to ensure good RF transmission.