Transmitter Channel A/B select

The pool side alarm RF (radio frequency) signal can be transmitted from the transmitter to the receiver inside the house by two different channels (A or B). All units are preset at channel A in the factory. However, if your alarm system interferes your neighborís alarm system, you may have to change your alarm unit to channel B.

The pool side alarm unit has a built-in channel select switch. This is located inside the battery compartment. Follows these instructions to change the channel.

1.Open the battery door and remove the battery. You can see an A/B slide switch located at the corner of battery compartment.

2.Use a screw driver to push the switch handle from A to B. Make sure to do the same channel adjustment on ALL your POOLEYE devices, including the receiver.