Murray 309007x8B manual HOW to Install the Seat, HOW to Assemble the Steering Wheel

ASSEMBLY

HOW TO INSTALL THE SEAT

Use the fasteners shown below to install the seat. The fasteners are shown at full size.

4.Check the operating position of the seat. If the seat needs to be adjusted, loosen the two wing bolts (A). Slide the seat for- ward or backward along the seat adjusting holes as shown. Tighten the wing bolts (A).

(A)	(B)
1001054	17x47

1.Carefully remove the plastic bag from the seat.

2.Raise the seat support and secure in the UP position with the seat support rod.

3.Align the holes in the seat to the holes in the seat support (Figure 1). Fasten the seat to the seat support with the fasten- ers as shown.

	Seat
	Adjusting Hole
	Seat
Seat Support	B
A
Seat Support Rod
	Figure 1

HOW TO ASSEMBLE THE STEERING WHEEL

Attach the steering wheel as follows:

1.Make sure the front wheels point forward.

2.Slide the tube into the console (Figure 2). Make sure the end of the tube fits over the steering bushing.

NOTE: Before attachment of the steering wheel, make sure that the front wheels point forward and are straight. The steering wheel will have either 3-spokes or 4-spokes. For proper alignment of the steering wheel, see Figure 2.

3.Slide the steering wheel and steering post into the tube and console. Push on the steering wheel. The steering post will lock onto the pinion gear. Pull on the steering wheel. Make sure that the steering post is locked in place.

Steering Wheel

Steering Post

Tube

Console

Straight

Figure 2

F−050611L 11