MAINTENANCE
HOW TO REPLACE THE FUSE
If the fuse is blown, the engine will not start. The location of the fuse is next to the battery. Remove the fuse and replace with a automotive fuse (Figure 35).
Automotive Fuse |
Figure 35 |
HOW TO CLEAN THE MOWER HOUSING
WARNING: Before you clean the mower housing, stop the engine and disconnect the wire to the spark plug.
Grass and other debris on top of the mower housing can keep the belt from working correctly. For safety and correct operation,
frequently clean the top of the mower housing. Remove grass and debris from around the pulleys and other moving parts.
1.Move the lever for the blade rotation control to the ENGAGE position.
2.Clean the top of the mower housing.
3.Move the lever for the blade rotation control to the DISENGAGE position.
4.Again clean the top of the mower housing.
5.After you cut the grass, clean the bottom of the mower housing.
STORAGE (over 30 days)
At the end of each year, prepare the unit for storage as follows.
THE ENGINE
For storage information, see the the engine manufacturer’s instructions.
THE FUEL SYSTEM
WARNING: Do not drain the gasoline inside a build- ing or near a fire. Do not smoke because the fumes from the fuel can cause an explosion.
1.Start the engine.
2.Run the engine until the fuel tank and the carburetor are out of fuel and the engine stops.
3.After storage, make sure you use fresh fuel.
THE BATTERY
1.Remove the battery.
2.Clean the battery terminals of any deposits.
3.Charge the battery. See the instructions on “How To Prepare And Charge The Battery”.
4.Store the battery in a cool, dry place.
NOTE: After a long time in storage, charge the battery.
CLEAN THE UNIT
1.Clean the dirt and grass from the engine.
2.Clean the mower housing.
LUBRICATE THE UNIT
See the “Lubrication” instructions in this book.
F−050611L | 34 |