HOW to Remove the Mower Housing

1.Move the blade rotation control to the DISENGAGE position.

2.Move the lift lever to the level adjustment position (Figure 29).

HOW TO INSTALL THE MOWER HOUSING

1.	Push the mower housing under the right side of the unit.
2.	Put the mower drive belt around the stack pulley. Make sure
	the “V” side of the mower drive belt is against the stack pulley.

NOTE: Make sure the lift lever is locked in the LEVEL ADJUSTMENT position.

3.Remove the hair pins and the washers from the rear suspen- sion arms (Figure 30). See il- lustrations “C” and “D”.

4.Remove the hair pins and wash- ers from the suspension links. See illustrations “A” and “B”.

Level Adjustment
Position	Figure 29

	Also, make sure the mower drive belt is not twisted.
3.	Attach the front hanger to the frame support with the hanger
	rod. Fasten with the fasteners as shown. See illustration “F”.
4.	Make sure the mower drive belt is between the stack pulley
	and the two belt guides. See illustration “G”.
5.	Attach the suspension links to the lifter assembly. Fasten
	with the washers and hair pins. See illustrations “A” and “B”.
6.	Attach the rear suspension arms to the suspension brackets.
	Fasten with the washers and hair pins. See illustrations “C” and
	“D”.

5.Disconnect the extension spring from the blade control rod. See illustration “E”.

6.Disconnect the front hanger from the frame support. See illustration “F”.

7.Remove the mower drive belt from the stack pulley. See illustration “G”.

8.Pull the mower housing away from the right side of the unit.

9.To operate without the mower housing, move the lift lever to the TOP position.

7.	Attach the extension spring to the blade control rod. See
	illustration “E”.
8.	Move the blade rotation control to the ENGAGE position.
	Make sure the mower drive belt is inside all the belt guides
	and is also below the spacer tube.
9.	Make sure the mower housing is level. See the instructions on
	“How To Level The Mower Housing”.
10.	Check the operation of the blade rotation control. See the in-
	structions on “How To Adjust The Blade Rotation Control”.