Murray 20-inch Push manual Engine Stop Cable Recoil-Start Grip Locknut, Rope Guide

Page 14

ASSEMBLY

3.Attach the engine stop cable to the en- gine. Models with Briggs & Stratton en- gines are shown in Figure 5. Models with Tecumseh engines are shown in Figure 6.

4.Make sure the engine stop cable moves freely. If the cable does not move freely, re- peat the above steps.

CAUTION: A cable that is bent or damaged will not work correctly. Before you use the unit, replace a damaged cable.

5.Attach the cable to the handle with the cable fastener(s) as shown in Figure 4.

CAUTION: If a cable fastener is missing, a cable can be too near the muffler. Heat from the muffler can damage the cable. Before you use the unit, replace a missing cable fastener.

WARNING: The blade will rotate when the engine runs.

6.Hold the engine stop lever against the handle. Slowly pull the recoil-start grip. To attach the recoil-start grip to the rope guide, twist the rope through the rope guide mounted on the right side of the handle Fasten with a locknut (Figure 7).

Briggs

Engine

Engine Stop

Cable

Figure 5

Tecumseh

Engine

Engine Stop

Cable

Engine

Stop Cable

Figure 6

Recoil-Start
Grip
	Locknut
	15x116
Rope Guide
F-050401L	14

Image 14

Contents Models MURRAY, INC. One Year Limited Warranty OWNER’S Information Responsibility of the OwnerSafe Operation Practices for Walk-Behind Mowers Use only original equipment or authorized replacement parts Do notThey can help you learn. Too often the mow Safe Mowing GuideTices. Read the next few pages carefully Read this Instruction Book. ReadAccessory and the mower Make the clean up after mowing easierAdjustment,except carburetor, while the en Bruises, or even put out an eye. Often the perAuthorized Service Center for your brand Stitutions as service parts. If you need profesSional service, select a shop that is an Mower. If you plan to service the unit yourselfWhen the front of the mower has come up Ufacturer’s recommended replacement partBefore using the grass catcher again Cause. Vibration is generally a warningAfter Mowing Steps to Follow Before MowingWhile Mowing Assembly Parts BAG ContentsTight Bolt Is not installed correctlyUnpacking Instructions NutHOW to Assemble the Controls to the Handle Models WithEngine Stop Cable Recoil-Start Grip Locknut Engine StopCable Rope GuideFinal Assembly HOW to Assemble the Wheels with Axle BoltsHOW to Prepare the Engine Hub Cap Flange Nut 15x68Operation HOW to Stop the EngineHOW to Start Engine Engine Stop LeverHOW to Clean Mower Housing MaintenanceEngine Maintenance HOW to Adjust Height of CUTHOW to Sharpen the Blade Blade ServiceHOW to Remove the Blade HOW to Prepare the Mower for Storage Check the Level of CUTTrouble Shooting Chart Engine will not startRepair Parts Mower Housing Description Loose Parts Hardware BagHandle Briggs & Stratton Models KEY DescriptionHandle Tecumseh Models Wheels and Tires Wheel Size & Type050401L HOW to Order Repair Parts MURRAY, INC. Lawn Mower Central Parts Distributors