Murray 20-inch Push Unpacking Instructions, Is not installed correctly, Tight Bolt, Nut, Chute

Page 12

ASSEMBLY

NOTE: In this instruction book, left and right describe the location of a part with the operator standing behind the handle.

UNPACKING INSTRUCTIONS

For shipping purposes, the mower was not fully assembled. To complete the assembly of the mower, follow the steps below.

HOW TO ASSEMBLE

THE CHUTE DEFLECTOR

WARNING: The chute deflector is necessary for your safety and protection. Do not operate the mower if the chute deflector is missing or

is not installed correctly.

1.Remove the mower from the carton.

2.Remove all packing material from the mower and the handle.

3.Attach the chute deflector to the mower housing with a bolt, washer, and nut (Figure 1). Make sure the fasteners are

tight.
Bolt
1x121
Washer
17x37
	Nut
	15x116
Chute
Deflector	Figure 1
	Figure 1

HOW TO ASSEMBLE THE HANDLE

1.Put the ends of the lower handle into the handle slots (Figure 2).

2.Attach each side of the handle to the mower housing with a bolt, washer, spacer, and nut (Figure 2). Tighten the bolts.

3.Assemble the upper part of the handle to the lower part with the screws and lock- nuts (Figure 3).

		Lower Handle
	Mower	Flange Nut
	Housing	Flange Nut
	Housing	15x84
		15x84
	Bolt
	1x111
		Spacer
		671914
	Washer	Figure 2
	845	Figure 2
	F-050401L	12

Locknut

15x116

Screw

3x136

Figure 3

Image 12

Contents Models MURRAY, INC. One Year Limited Warranty OWNER’S Information Responsibility of the OwnerSafe Operation Practices for Walk-Behind Mowers Use only original equipment or authorized replacement parts Do notSafe Mowing Guide Tices. Read the next few pages carefullyThey can help you learn. Too often the mow Read this Instruction Book. ReadMake the clean up after mowing easier Adjustment,except carburetor, while the enAccessory and the mower Bruises, or even put out an eye. Often the perStitutions as service parts. If you need profes Sional service, select a shop that is anAuthorized Service Center for your brand Mower. If you plan to service the unit yourselfUfacturer’s recommended replacement part Before using the grass catcher againWhen the front of the mower has come up Cause. Vibration is generally a warningSteps to Follow Before Mowing While MowingAfter Mowing Assembly Parts BAG ContentsIs not installed correctly Unpacking InstructionsTight Bolt NutHOW to Assemble the Controls to the Handle Models WithEngine Stop CableEngine Stop Cable Recoil-Start Grip Locknut Rope GuideHOW to Assemble the Wheels with Axle Bolts HOW to Prepare the EngineFinal Assembly Hub Cap Flange Nut 15x68HOW to Stop the Engine HOW to Start EngineOperation Engine Stop LeverMaintenance Engine MaintenanceHOW to Clean Mower Housing HOW to Adjust Height of CUTBlade Service HOW to Remove the BladeHOW to Sharpen the Blade HOW to Prepare the Mower for Storage Check the Level of CUTTrouble Shooting Chart Engine will not startRepair Parts Mower Housing Description Loose Parts Hardware BagHandle Briggs & Stratton Models KEY DescriptionHandle Tecumseh Models Wheels and Tires Wheel Size & Type050401L HOW to Order Repair Parts MURRAY, INC. Lawn Mower Central Parts Distributors