Throttle/ ChokeControl
The throttle/choke control is located on the right side of the tractor's dash panel. This lever controls the speed of the engine and, when pushed all the way forward, closes the choke for cold starting. When set in a given position, the throttle will maintain a uniform engine speed.
IMPORTANT:When operating the tractor with the cutting deck engaged, be certain that the throttle/choke control is always in the FAST (rabbit) position.
Oh0ke Position
IgnitionSwitchModule
WARNING: Never leave a running machine unattended. Always disengage the PTO, move the shift lever into Neutral, set the parking brake, stop the engine and remove the key to prevent unintended starting.
To start the engine, insert the key into the ignition switch and turn clockwise to the START position. Release the key into the NORMAL MOWING MODE position once the engine has fired.
To stop the engine, turn the ignition key counterclockwise to the STOP position. See Figure 8.
BrakePedal
The brake pedal is located on the right front side of the tractor above the drive pedal along the running board. The brake pedal can be used for sudden stops or setting the parking brake.
NOTE: The brake pedal must be fully depressed to activate the
safety interlock switch when starting the tractor.
ShiftLever
The shift lever is located on the left side of the fender and has three positions, FORWARD, NEUTRAL and REVERSE. The brake pedal must be depressed and the tractor must not be in motion when the moving shift lever.
IMPORTANT:Never force the shift lever. Doing so may result in
serious damage to the tractor's transmission.
DeckLiftLever
Found on your tractor'sright fender, the deck lift lever is used to change the height of the cutting deck. To use, move the lever to the left, then place in the notch best suited for your application.
(o)
*F
N
Stop | Normal | |
Position | ||
- Mowing Mode | ||
| ||
| Start | |
| Position |
Figure 8
IMPORTANT:Prior to operating the tractor, refer to both SafetyInterlock Switcheson page 16 and StartingThe Engine on page 17 of this manual for detailed instructions regarding the Ignition Switch Module and operating the tractor in REVERSE CAUTION MODE.
DrivePedal
The drive pedal is located below | /,/_,_ |
the brake pedal on the right front | %_/ |
| |
side of the tractor along the |
|
running board. Depress the drive |
|
pedal with your right foot when |
|
the tractor shift lever is in either |
|
FORWARD or REVERSE to |
|
cause the tractor to move. |
|
Ground speed is also controlled with the drive pedal. The further
down the pedal is depressed, the faster the tractor will travel. The pedal will return to its original position when released.
14