Toro 13AX60RH744, 13AX60RG744 Makingadjustments, SeatAdjustment, LevelingtheDeck, Front To Rear

Page 19

SECTION7: MAKINGADJUSTMENTS

adjustments while the engine is running,

_, ARNING: Never attempt to make any

SeatAdjustment

To adjust the position of the seat, loosen the two knobs on the bottom of the seat. See Figure 11. Slide the seat

forward or rearward as desired. Retighten the two knobs.

4.Determine the approximate distance necessary for proper adjustment and proceed, if necessary, to the next step.

5.From the front of the tractor, loosen the outermost hex lock nut(s) on the end(s) of the deck hanger rod. See Figure 12 or Figure 13.

6.Tighten the inner hex nut(s) front against the front

hanger bracket to raise the front of the deck; loosen the hex nut to lower the front of the deck. See

Figure 12 or Figure 13.

Figure 11

LevelingtheDeck

LX 420

Figure 12

LX 460

NOTE: Check the tractor's tire pressure before performing any deck leveling adjustments. Refer to Tires on page 26 for information regarding tire pressure.

Front To Rear

The front of the cutting deck is supported by a stabilizer

bar that can adjusted to level the deck from front to rear. The front of the deck should be between 1/4-inch and

3/8-inch lower than the rear of the deck. Adjust if necessary as follows:

1.With the tractor parked on a firm, level surface, place the deck lift lever in the top notch (highest position) and rotate the blade nearest the discharge chute so that it is parallel with the tractor.

2.Measure the distance from the front of the blade tip

to the ground and the rear of the blade tip to the

 

Figure 13

ground.

,

Retighten the two lock nuts against the inner hex

3. The first measurement taken should be between

 

 

nuts when proper adjustment is achieved.

1/4" and 3/8" less than the second measurement.

 

 

 

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents LX420 & LX460 Lawn Tractors Tableofcontents General Operation ImportantsafeoperationpracticesDataindicatesthatoperators,age60yearsand Service Safetysymbols Mowingin Reverseisnotrecommended Reversecautionmode SafetyandinstructionallabelsDangefposon 15o Tools Required AttachingtheBatteryCablesTRACTORSET-UP AttachingTheSteeringWheelAttachingTheSeat Tire PressureShippingBraceRemoval GasandOilFill-up SettingtheGaugeWheelsKnowyourlawntractor DeckLiftLever IgnitionSwitchModuleBrakePedal ShiftLeverParkingBrakeLever SystemsIndicatorMonitor/ HourMeterPTOBladeEngageLever CruiseControlLeverReverseCautionMode SafetyInterlockSystemIndicator OperatingyourlawntractorDrivingTheTractor SettingTheCruiseControlStartingthe Engine Stoppingthe EngineMowing Usingthe DeckLiftLeverEngaged Front To Rear MakingadjustmentsSeatAdjustment LevelingtheDeckParking BrakeAdjustment SteeringAdjustment Adding Oil MaintainingyourlawntractorEngine EngineOilChangingthe Oil Filter ChangingtheEngineOilAirFilter FrontWheels CleaningtheEngineFuelFilter EngineCuttingBlades ServiceTires FuseCharging BatteryCuttingDeckRemoval Jump StartingChangingthe Lower DeckBelt Model LX460 only ChangingTheTransmissionDriveBelt ChangingtheDeckBeltLX460 OFF-SEASONSTORAGE Hours MaintenancechartEvery PriorPossible Causes TroubleshootingLX460 SpecificationsCapacities TECAJCIANATOR30 CIR YEL Manufacturers Warranty Coverage Toro Company
Top Page Image Contents