Weed Eater RT112, RT110 instruction manual Troubleshooting Table Cause Remedy

Page 8

WARNING: Perform the following steps after each use.

S Stop the unit and disconnect the power source when not in use.

SCarry the unit with motor stopped.

SStore the unit so the line limiter blade can- not cause injury.

S Store unit and extension cord indoors in a high, dry place out of the reach of children. Store unit unplugged.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci- dentally cause injury.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that require unit to be operating.

TROUBLE

CAUSE

REMEDY

Trimmer head

1.

Crowding trimmer line

1.

Allow tip of line to do the cutting.

stops under a

 

against material being

 

 

load or does not

 

cut.

2.

Contact your authorized service dealer.

turn when switch

2.

Electrical failure.

is pressed.

3.

Thrown circuit breaker.

3.

Check Breaker Box.

 

4.

Debris stopping head.

4.

Remove debris.

 

 

 

 

 

Line does not

1.

Line improperly routed

1.

Check line routing.

advance or

 

in head.

 

 

breaks while

2.

Line improperly

2.

Rewind line tightly and evenly.

cutting.

 

wound into spool.

3.

Use only 0.065 in. (1.65 mm) dia. line.

 

3.

Incorrect line size

 

4.

Not enough line

4.

Remove cover and pull 4 inches

 

 

outside of head.

 

(10 cm) of line out of head.

 

5.

Dirt buildup on unit.

5.

Clean unit.

Line welds onto

1.

Line size is incorrect.

1. Use only 0.065 in. (1.65 mm) dia. line.

spool.

2.

Incorrect spool.

2. Replace with correct spool.

 

3.

Line is being crowded

3. Cut with tip of line fully extended.

 

 

against material being

 

 

 

 

cut.

 

 

Line releases

1.

Line improperly

1. Check line routing.

continuously.

 

routed in head.

 

 

 

2.

Spool damaged.

2. Replace spool.

 

 

 

 

Line usage is

1.

Line improperly routed

1. Check line routing.

excessive.

 

in head.

 

 

 

2.

Line size is incorrect.

2. Replace spool.

 

3.

Crowding line against

3. Cut with tip of line fully extended.

 

 

material being cut.

4. Replace spool.

 

4.

Spool worn or damaged.

 

 

 

Line pulls back

1. Too little line outside

1. Remove cover and pull 4 inches

into head.

 

of head.

 

(10 cm) of line outside of head.

 

2. Line size incorrect.

2. Use only 0.065 in. (1.65 mm) dia. line.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Advertencia AvertissementOperator Safety Electrical SafetyUnit Safety Cutting SafetyMaintenance Safety Transporting and StorageAttaching the Shield Installation of Assist HandleAlign Installation Arrows Operating Instructions Correct Operating Position Advancing the Cutting LineBefore Each USE After Each USETroubleshooting Table Cause Remedy Electrolux Home PRODUCTS, INC

RT110, RT112 specifications

The Weed Eater RT112 and RT110 are two significant models in the realm of outdoor power equipment, specifically designed for homeowners and gardening enthusiasts. These string trimmers have gained a reputation for their reliability, performance, and ease of use, making them ideal for tackling lawn maintenance tasks with efficiency.

One of the standout features of the RT112 is its powerful engine. Equipped with a 25cc two-cycle engine, it provides the necessary power to handle tough grass and weeds. The RT110, while slightly less powerful, still boasts a robust 22cc engine that offers a perfect balance of performance and fuel efficiency for lighter tasks. Both models are designed for easy cold starting, allowing users to get to work quickly, even if the machine has been sitting for a while.

The line feed system is an essential characteristic of these trimmers. The RT112 and RT110 utilize a reliable, bump feed mechanism that allows users to easily advance the cutting line with a simple tap against the ground, making the trimming process more efficient and less interrupted. The cutting width of these models is around 16 inches, providing a perfect blend of productivity and maneuverability in tighter spaces.

Another notable technology in both the RT112 and RT110 is the lightweight design. Weighing less than 10 pounds, these trimmers are easy to handle and reduce user fatigue during extended periods of use. The ergonomic handle design improves comfort, while the adjustable shaft allows for customization to suit different user heights, enhancing overall ease of use.

Durability is another important feature of the RT112 and RT110. Constructed with high-quality materials, these trimmers are built to withstand the rigors of outdoor tasks. Additionally, the protective shield helps to deflect debris away from the user and the machine, ensuring safe operation.

The Weed Eater RT112 and RT110 are both designed with user convenience in mind. They feature easy-reach controls that allow for quick adjustments, making it simple to switch between various trimming tasks. Overall, the combination of power, comfort, and efficiency in these models makes them excellent choices for anyone looking to maintain their outdoor spaces effectively. Whether you're tackling tough weeds or simply shaping the edges of your lawn, the Weed Eater RT112 and RT110 deliver reliable performance for all your trimming needs.
Top Page Image Contents