Weed Eater 952711796 Assembly, Operation, Adjusting the Handle, Attaching Shield

Page 5

ist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arrest- ing screen will not require any service.

After 50 hours of use, we recommend that your muffler be serviced or replaced by your authorized service dealer.

ASSEMBLY

WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.

Examine parts for damage. Do not use dam- aged parts.

NOTE: If you need assistance or find parts missing or damaged, call 1-800-554-6723. It is normal for the fuel filter to rattle in the empty fuel tank.

Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.

ADJUSTING THE HANDLE

WARNING: When adjusting the assist handle, be sure it remains above the safety label and below the mark or arrow on the shaft.

1.

Loosen wing nut on handle.

2.

Rotate the handle on the shaft to an upright

 

position; retighten wing nut.

ATTACHING SHIELD

WARNING: The shield must be prop- erly installed. The shield provides partial protec- tion from the risk of thrown objects to the opera- tor and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you.

For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OPERATION section.

1.Remove wing nut from shield.

2.Insert bracket into slot as shown.

3.Pivot shield until bolt passes through hole in bracket.

4.Securely tighten wing nut onto bolt.

Slot Bracket

PIVOT

Wing Nut

Gearbox

Shield

OPERATION

KNOW YOUR TRIMMER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

Trimmer

Shaft

Assist Handle

 

Muffler

 

 

 

Head

 

Safety Label

Shaft Mark or Arrow

 

 

 

Shield

 

 

Throttle

 

 

Spark Plug

Primer

 

 

Trigger

 

 

 

Bulb

Line Limiter

STOP

Blade

Switch

 

 

Choke Lever

 

Fuel Mix Fill Cap

Starter Handle

5

Image 5
Contents Manual de Instrucciones Manuel d’Instructions Hazard zone for thrown objects Identification of Safety SymbolsOperator Safety Safety RulesFuel Safety Unit / Maintenance SafetyCutting Safety Transporting and StorageAdjusting the Handle AssemblyOperation Attaching ShieldHOW to Stop Your Unit Stop SwitchHOW to Start Your Unit Primer BulbStarting a Flooded Engine Starting a Warm EngineOperating Position Trimmer Line AdvanceTip of line does Cutting MethodsCutting Work area Inches 8 cm above groundService and Adjustments MaintenanceReplacing the Cutting Head Carburetor Idle Speed AdjustmentSeasonal Storage Fuel SystemOther Troubleshooting Table Cause RemedyEngine Weed Eater Limited WarrantyIntermediate 125 hours Extended 300 hours