Siemens S7-300F-2 PN, DP manual Industry Automation and Drive Technologies SCE

Page 19

Industry Automation and Drive Technologies - SCE

14.Now, drag the PROFINET IO System (100) module tier toward the right and from the folder PROFINET IO, insert the SIMATIC RFID module RF180C into the module tier by dragging it there.

If module RF180C should not yet be selectable, it first has to be inserted by a data carrier, using the menu "Options“ Install GSD files.

15.Then, double click on the inserted module and change the device name to RF180Cx110 and the IP address to 192.168.0.110

16. By clicking on '	’, the hardware configuration is saved and compiled.
TIA Training Document	Page 19 of 65
Module E11
Status: 01/2010	Radio Frequency Identification (RFID) with SIMATIC S7-300F-2PN/DP and
RF180C

Image 19

Contents Industry Automation and Drive Technologies SCE Module E11Industry Automation and Drive Technologies SCE Preface Page Objective S7’Prerequisites Simatic RF180C ASM Industry Automation and Drive Technologies SCE CPU Rfid Fundamentals DB47 Data structure of the German language UDTs is as followsPage Industry Automation and Drive Technologies SCE Page Industry Automation and Drive Technologies SCE Industry Automation and Drive Technologies SCE Value range for the address of the gateway router Industry Automation and Drive Technologies SCE MAC addressValue range for the IP address Value range for the subnet screen formIndustry Automation and Drive Technologies SCE Industry Automation and Drive Technologies SCE Industry Automation and Drive Technologies SCE Page Page Page Save and close DB48 Generating DB48 Open DB48, set up 1024 bytesGenerating DB49 Open DB49 and insert UDT261 and UDT271 Page Generating DB50 Open DB50 and insert UDT111 and UDT281 Save and close DB50 Generate DB47 Open DB47 and add UDT21 for each request Save and close DB47 DB45, UDT11 is called for each reader Generating DB45 Open DB45 and insert UDT11 for each readerData view of DB45 to byte DB47 request data block is referred to in DB45Save and close DB45 Page Generating Function FC11 Set up in variables Set up OUT variablesSave and close FC11 Reading data from the transponder Data View of the UDT21 Command OverviewCommand Writing data to the transponderRead out Reader status Command NextCommand END Initialize TransponderTransponder Status Switching the reader aerial on/offExample of a command string in DB47 Data view of the UDT11 Variable Description Parameter commandDBaddress Value = 50 for Reader2 507 Industry Automation and Drive Technologies SCE ISO MDS Page Page Industry Automation and Drive Technologies SCE Variable Description Control bits from Bit8 to Bit15Moby U/D or RF300 Generating FB10 Then, set up in variables Next, set up OUT variablesReader block Network 1 Command start Network 2 Reset Reader Industry Automation and Drive Technologies SCE Networks 4 to Page Task Supplementing the symbol tableGenerating FB1 Industry Automation and Drive Technologies SCE FB10 is inserted as a multi-instance block Industry Automation and Drive Technologies SCE Network Industry Automation and Drive Technologies SCE Network 4 to Page Open OB1 and call FB1 with DB1 Page Page Industry Automation and Drive Technologies SCE Symbol Table