ASSEMBLY OF ENGINE AND SHAFT FOR EM4340, EM4341
CAUTION: Before doing any work on the brush cutter, always switch off the motor and pull the spark plug connector off the spark plug. Always wear protective gloves!
CAUTION: Start the brush cutter only after having assembled it completely.
–After checking the parts, fasten the drive shaft to the engine with four bolts M6 x 22(1).
–Mount the stand by two screws M5 x 14.
(1)
(2)
MOUNTING OF HANDLE FOR EM4340, EM4341
For EM4340
–Place the handle with the throttle lever on the handle holder on the right side (to be held by the right hand) and the other on the left side.
–Fit the handle edge to the handle holder groove, and provisionally fix the upper side (3) of the handl e holder by four bolts M5 x 25 (4).
–Adjust the handle to an angle easy to manipulate, and tighten the bolt (4) uniformly on the right and left sides.
(4)
(3)
–Fix the control cable to the shaft by two clips (5).
Clips (5)
9