For EM4341
–Fit the handle edge to the handle holder groove, and provisionally fix the upper side (3) of the handle holder by four bolts M5 x 25 (4).
–Adjust the handle to an angle easy to manipulate, and tighten the bolt (4) uniformly on the right and left sides.
Note: Handle mounting position.
–Pass the control cable (6) through the rear grip (7) and insert tube (8) in the control cable (6).
–Fix the control cable to the handle and shaft by two clamps.
Note: If the control cable is not tight, it may be caught by a twig, leading to an accident.
Lay out the control cable as indicated in the figure.
Note: If the control cable is not tight, it may be caught by a twig, leading to an accident.
(4)
(3)
to engine
(6)
(8)
(7)
10