Makita ER2650LH dimensions Clutch drum

Repair

P 6/ 14

[4]DISASSEMBLY/ASSEMBLY

[4]-5. Clutch

DISASSEMBLING

Disassemble Clutch by removing Shoulder hex bolt M6x25 (2pcs) with Cordless impact driver using 13mm Socket bit. (Fig. 12)

Fig. 12

Note:

•Clutch is removed with Cordless impact driver without locking Piston.

•Do not remove Spark plug because compressed air resistance in Cylinder is used for Piston locking.

•Remove Plug cap to prevent accidental engine start.

13mm Socket bit

Shoulder hex bolt M6x25 (2pcs.)

ASSEMBLING

Assemble Clutch by following steps in Fig. 13.

Fig. 13

1. Marking “L” on Clutch	L	3. Tighten Shoulder hex bolt
must face up.		M6x25 by hand.

2.Place Washer 8 at described direction.

4.Set 13mm Socket bit to Cordless impact driver and tighten Shoulder hex bolts.

[4]-6. Clutch drum

DISASSEMBLING

(1)Remove Clutch case section from the engine by unscrewing H.S.H. bolt M5x8 (3pcs).

(2)Remove Retaining ring S-12 with 1R004 from Clutch drum in the Clutch case.

(3)Remove Clutch drum from Clutch case section using 1R247 and Arbor press. (Fig. 14)

Fig. 14

Arbor press 1R247

Clutch case

ASSEMBLING

(1)Put Clutch case on the table of Arbor press vertically, and then, press-fit Clutch drum into Ball bearing 6201LLU with 1R286 and Arbor press. (Fig. 15)

(2)Set Retaining ring S-12 in place with 1R004.

Fig. 15

1R286

Clutch drum

Clutch case