Makita ER2650LH dimensions Repair DISASSEMBLY/ASSEMBLY 4-9. Recoil starter

Repair

P 9/ 14

[4]DISASSEMBLY/ASSEMBLY [4]-9. Recoil starter

DISASSEMBLING

Remove Recoil starter assembly from Engine unit and disassemble it. (Fig. 22)

Fig. 22

1.Remove Recoil starter assembly from Engine unit. Then, pull out and cut Starter rope if it is still wound on Reel. In case the Starter rope can not be cut, pull it for a length of one round of Reel and hook it in the U-notch,

then turn the Reel clockwise until Spiral spring is loosened.

M5x12 Tapping	U-notch of Reel
screw (Set screw)

2.Remove M5x12 Tapping screw and Swing arm, Collar and Reel from Starter case.

Note: Be careful if Spiral spring jumps out.

3.Loosen rope knots in the Starter knob and Reel, then remove the rope.

Starter knob	Collar	Swing arm
	Reel
		M5x12
		Tapping screw
Starter		(Set screw)
case

ASSEMBLING

Set Spiral spring in Reel if it is out of Reel and assemble Recoil starter assembly, then wind Starter rope by using recoil force of Spiral spring.

Fig. 23

1.First, set Outer hooked end of Spiral spring in Reel and wind it clockwise toward center of Reel. Set Inner hooked end of Spiral spring on the rib inside of Reel.

2.Apply Makita grease N No.2 a little to the entire Spiral spring.

3.Pass a new Starter rope through Starter case and Knob, then make knots at both ends

Approx. 10mm

Outer hooked end	Starter case	Starter knob
of Spiral spring
Inner hooked end
of Spiral spring	Reel
		Approx. 10mm

Reel
4. Wind the rope with Reel for		5. Mount Collar to Reel and pass			6. Hook the rope in the notch of Reel
2 to 3 turns and fix Reel in
		the arm of Swing arm in the slot			and turn Reel counterclockwise by
Starter case while turning it
		of Reel, then fix them to the Reel			using the rope as handle. The rope
left to fit the inner hooked end
		with M5x12 Tapping screw.			is wound by recoil force of Spiral
of Spiral spring in the slot on
		Note: Repeat the step 4 to 5. in case			spring when it is released from
Starter case.
		the movement of Reel is not			the notch. Repeat the step till
Note: Reel should be fixed
		smooth after the screw is tightened.			the rope is wound up completely.
without force.
					notch of Reel
	Slot of		Swing arm	M5x12
Inner hooked end
	Reel to hook		Collar	Tapping screw
of Spiral spring
				(Set screw)
Slot on	Swing arm
Starter case				Damper
				spring